Part Number: TPS563208 Hi Team,
What if the Vout of our TPS563208 has existing voltage(nearly 1.5V) from other system side, but our device hasn't been enabled. What's the potential risk for our device?
Best,
Stanley
Part Number: TPS563208 Hi Team,
My Customer used JW5060 for the MCU aux power, but there has some ripple noise issue in light load,
they do not need the skip mode or burst mode in light load or no load, the TPS563208 (Continuous Current Mode) cant be reduced…
Part Number: TPS563208
Hello there,
I am trying to calculate the maximum output voltage ripple for a device using the TPS563208. I need to know, how to optimize the output capacitors value for the given (known) maximum load, inductor value, and input…
Part Number: TPS563208 Hello,
Thanks for your attention.
We have seen if we didn't put 0.1uf cap near EN pin of TPS563208, when pull up voltage(12V) rise from 0V, the EN will have ringing as figure below, if the 12V rail is not rise start from 0V, the…
Part Number: TPS563201 Other Parts Discussed in Thread: TPS563208 Hi
I read the datasheet of TPS563201. However I do not understand what is the difference of the both device (TPS563201 and TPS563208).
As it's mentioned at the datasheet, the both device…
Part Number: TPS563201 Other Parts Discussed in Thread: TPS563208 , TPS563200 Hi
#1
I need to design a 12V DC input and output will be 4V /2~3A buck , so i would like to choose either TPS563201 (light load at Pulse-skip mode ) or TPS563208 (CCM) ;But I…
Part Number: TPS563208 Hi, Team,
We have questions for TPS563208. There is Vout > Vin condition on the customer board. Please refer the below blocks.
1. Is it ok to use TPS563208 in this condition?
2. Should they use discharge register? Or should they…
Part Number: TPS563208 Hi Team,
1. The waveform below was tested from TPS253201, does TPS263208 has the same performance?
2. For Figure34, Vout shutdown because of the UVLO 3.6V, am I right?
3. Does TPS56x20x has output discharge function?
4. About the…
