Part Number: TPS56C215 Hi Team,
May I have your help to review the design schematics and layout to check if there are any problems?
Please send mail to me and I will provide the data since it is confidential to open in pubic.
My email is: peter…
Part Number: TPS56C215
Hi TI team,
I have completed the schematic design using the TPS56C215 in my project. Could you please help review my schematic to ensure that the component selection and connections are correct?
Also, I would like to know…
Part Number: TPS56C215 Tool/software: Comparing the old datasheet with the latest datasheet, we found the following two differences.
1. OOB (Out-of-Bounds Operation) is no longer mentioned.
2. In the description of Thermal shutdown, the description…
Part Number: TPS56C215 Tool/software: I have a question regarding the TPS56C215. The MODE pin register is set to 800kHz. However, the measured frequency is approximately 700kHz. Is this within the product's guaranteed range? Additionally, could you provide…
Part Number: TPS56C215 Other Parts Discussed in Thread: TIGER Hi,
According to datasheet revision history from G version to H, the soft start time is changed from 1.045mS to 1.2mS. As my understanding, it is internal soft start specification.
And…
Part Number: TPS56C215 Tool/software: Hi Team
do we have any buck converter which vout can be controlled by I2C interface.
below is spec requirement
Vin:12V
Vout: +5V ~ -5V
Iout:1A.
BRs
Brian
Part Number: TPS56C215 Tool/software: Dear E2E Forum,
I'd like to place a decoupling capacitor at the mode pin of TPS56C215. How much capacitance can this pin tolerate?
There's 200kR from VREG5 to MODE and 10kR from MODE to PGND, so according to Table…
Part Number: TPS56C215 Tool/software: Hi team,
I understand that the high and low SW voltages are VIN and GND. How much do they vary in range? Ex: VSW(high) is VIN +/- XX%, VSW(low) is GND +/- YY% Best regards, Goto
