Part Number: TPS59641 Hi,
We have used IMPV-7 (SVID) based PMIC for Intel Atom (E3826).
Our Operating condition: - ( 1 CPU and 1 GPU).
During the board bring-up, we have observed that after asserting VR_ON enable signal, CPU supply (1.1V) is being generated…
Part Number: TPS59641 Hi,
I have connected TPS59641 IMVP-7 regulator with Intel Atom E-3826 for Core & Uncore supply.
As we know SoC will use its SVID interface to set the VID voltage. For this operation, would it need to know the address of the…
Part Number: TPS59641 Hello,
We have completed the schematic & board design with IMVP-7 Multi-phase regulator "TPS59641".
Here You are requested to review the schematic for once, this will really help us.
I have commented down our operating…
Part Number: TPS59650 Other Parts Discussed in Thread: TPS59641 Hello TI Team,
I have talked with TI Supports about this component's simulation. Now my all other doubts are clear, Thanks TI for the response.
Now I have one last thing to get confirmed…
Part Number: TPS59641 Other Parts Discussed in Thread: TPS59650 Dear Support,
I am working on the Power Management Solution for "Intel Atom Processor E3826" .
In Bakersport Design Document for Intel Corporation, TPS59641 regulator is used to derive…
Part Number: TPS59650 Other Parts Discussed in Thread: TPS59641 , TPS51650 , TINA-TI Hello TI Team,
My design part is almost completed. But, today I read an article on TI E2E design forum that TPS59650 can not be used as an alternative of TPS59641 due…
Hello Nitin,
I'm closing this thread due to inactivity. If additional support is required regarding this question, you can reopen the thread by replying to this message.
Thanks,
Travis
Part Number: TPS59641 Other Parts Discussed in Thread: TPS59650 Hi,
Our customer is using TPS59641RSLR to drive Baytail E3800 sreise.
Our Customer need Vboot=1.0V or 1.1V and IMVP7 compliant device.
Please let us know the alternative of TPS59641RSLR. …
Part Number: TPS59641 Hi Sirs,
We test Bay-trial platform unstable (system hang) and found the big overshoot on high-side gate (HG) and switching node (SW).
If we increase R359 = 10ohm to reduce overshoot, the system is stabled.
My question is
1. Where…
Part Number: TPS59641 Hi,
If used as 1-Phase CPU , CCSP2 & CCSP3 must be connected to +3.3V, or only CCSP2 must be connected to +3.3V?
On our design, CCSP3 is connected to the Ground.
Thank you,