Part Number: TPS61022 Hi, We are generating 5V for the system by boosting from the supercapacitor voltage.
The booster is faulty in two devices, and both are faulty at the same point. The attached images show the schematic, layout, and failure path…
Part Number: TPS61022
Hi Team,
Posting on behalf of our customer.
I'll share this E2E post with our customer so he can reply when needed.
I am designing a high-current boost converter using the TPS61022 . My operating parameters are roughly…
Part Number: TPS61022 Dear TI support team,
In order to obtain stable 5V supply, a tps61022 is applied on a board and powered by USB-type C from PC. The sch was designed as same as the recommended in the datasheet. Recently, many boards damaged suddenly…
Part Number: TPS61022 Tool/software: I am using TPS61022 in my design, My output power requirement is 4V 2A for input voltage range 1.8V to 3.7V_DC. but when I am testing the circuit it works for only 500mA Load for 1A Load current output voltage drop…
Part Number: TPS61022 Tool/software: Hi,
I have a design with the TPS61022, the input range is 2.7-4.3V and the output is 5V@3A.
I use the output to power a leds (100ms ON, 900ms OFF). It works fine, but if I touch the DC/DC zone with the finger…
Part Number: TPS61022 Hi TI Team,
In the below attached Image of TPS61022 Datasheet, seems like Ven_h/Vmode_h values specified are Min Values, but in the datasheet it's been specified under Max Value
Similarly for Ven_l/Vmode_l values specified are…
Part Number: TPS61022 power_management_schematic.pdf
This is the circuit i have design for battery charging circuit through USB C Type and then powering two voltage regulator. I want to be so sure that my circuit design is ok. Can you kindly verify…
Part Number: TPS61022 Other Parts Discussed in Thread: TPS63900 , , TPS63820
Hi, everone! I like to swap for a BUCK BOOSTER with Iq iqual or higher TPS63900, with a 1.5A output. The TPS61022 has a Iq so higher. How I can filter the Power Designer Toll…
Part Number: TPS61022 Other Parts Discussed in Thread: TPS61033 Dear Team,
we have following situation
Vin 3.3V
Vout 3.6V
Iout max 0.3A
We use standard the TPS61022 prst for our boost desing, would you in this situation also recommend this…
Part Number: TPS61022 Hello,
We want a regulator that can support a low input voltage of 0.8V to 6V (max). The output voltage of the regulator must be between 3.1V and 4.5V with a nominal voltage of 3.8V.
The part should be low cost and low current…
