Part Number: TPS61071-Q1 Other Parts Discussed in Thread: TPS61071 , TLV61046A Hi team,
I am using TPS61071+TLV61046A for my project use two alkaline batteries in series boost to 3.3V for MCU and analog amplifier, boost to 12V for OLED.
Part Number: TPS61071-Q1 Other Parts Discussed in Thread: TPS61070 , TPS61073 , TPS61072 , , TPS61071 , TLV61220 Hello,
I need that up-converter for my application which is a PCB Mother Board which need to up convert 1.9v to 3.5v. It is a PCB which conected…
Part Number: TPS61071-Q1
I need a boost converter for up converting 2.9v or 3.3v to +3.5v and -3.5v. I found in TI web-site the TPS61071 Boost converter.
In the beginning of its Datasheet it says that in its typical application it converts only…
Part Number: TPS61071-Q1 Other Parts Discussed in Thread: TPS61071 Hi
I have questions about layout of TPS61071-Q1.
Could you tell me under questions
①Top is 1 layer, bottom is 2 layer, is this understanding correct?
Even granted that it is correct…
Part Number: TPS61071-Q1 Hi
I have three questions about TPS61091-Q1.
The VFB is typ 500mV(±10mV) at Ta=25℃ in datasheet.
Could you tell me the VFB over temperature?
Is the L1 of equation (3) and (4) the maximum average inductor current…
Part Number: TPS61071-Q1 Tool/software: WEBENCH® Design Tools Hi
I simulated TPS61071-Q1 under Vin=3.3V, Vout=5V, Iout=200mA by Webench.
But I couldn't simularted it because switch current limited exceeded.
I think this device can operate that condition…
Part Number: TPS61071-Q1 Hello,
for EMC reasons we want to use a 22µH inductor instead of the recommended 10µH.
The data sheet says the optimal range is up to 10µH, but higher values can also work and stability should be evaluated.
For the first revision of the design, the smaller inductor will be populated and tested. If there are issues with audible noise then the larger 4.2 mm x 4.2 mm inductor will be tried. If audible noise is still present then we'll look at using…