Part Number: TPS61093-Q1
Hi Team,
Could you share a transient SPICE model that works with SIMetrix tool.
Also is there a SIMPLIS model or a small signal model for AC analysis?
Regards,
Mithun
Part Number: TPS61093-Q1 What is the min or max soft-start time supported by the IC.
Can the soft-start time reach as high as 100ms, if I put a 1uF cap on the SS pin?
Best Regards,
Mithun
Part Number: TPS61093-Q1 Hi team,
My customer acceptable for voltage fluctuation on TPS61093-Q1.
In datasheet, voltage changes nearly 500mV when load change.
Is there any way to suppress this fluctuation?
Regards,
Youhei MIYAOKA
Part Number: TPS61093-Q1 Hi team,
My customer have questions about 9.2.1 15V Output Boost Converter in datasheet.
1. How much RV required for C3.
2. Is it possible to add snubber circuit even diode integrated.
3. In 7.3 Recommended Operating Conditions …
Other Parts Discussed in Thread: TPS61093-Q1 Hi
My customer will use TPS61093-Q1 under Vin=3.3V, Voiut=5V.
But calculation method of Iout_max isn't written in that datasheet.
Are there the reference materials or calculation methods of Iout?
Best regards…
Other Parts Discussed in Thread: TPS61093-Q1 Hi
The datasheet of TPS61093-Q1 is written that Ta and Tj is -40 ~-125℃ in "7.3 Recommended Operating Conditions". But when Ta was 125℃, I think Tj is over 125℃. So, is this case out of recommending…
Hi Cho,
Q1--> TLV61046A can not output 55 to 60mA with the conditions you provided.
Q2-->For Vin 1.8V to Vout 16.5V with Iout 55mA ~ 60mA, TPS61093 can be the available option. Please check whether it is applicable to your applications. If not, we may…
Part Number: TPS61041-Q1 Other Parts Discussed in Thread: TPS61093 , TPS61093-Q1 Hi all,
Iq is on the data sheet.(P.5)
However, VFB is 1.3 V and it is in no switching operation.
I want to know the average current of current consumption.
When Iout=0mA ,what…
Part Number: TPS61087-Q1 Other Parts Discussed in Thread: BQ25570 , TPS61087 , TPS61093 , TPS61085 , TPS65217 Hi colleagues,
I need your help/feedback regarding the best circuit design for my application project.
My Objective:
To power a 5Watts sensor during…