Part Number: TPS61161 Other Parts Discussed in Thread: TPS61160 , , TPS61160A , ,
Team,
-Can you please confirm if the different below GPNs can be use as P2P dropped-in replacement? -What should be done in the schematics/PCB in order to use them intercheangibly…
Part Number: TPS61165 Other Parts Discussed in Thread: TPS61158 , , TPS61161 , TPS61160 The datasheet for the TPS61165DRV shows a thermal resistance junction/board of 140.2°C/W, which seems too high. It is higher than its own junction-to-case and junction…
I'm afraid I have no idea. If you are going to try TPS61160, another suggestion is TPS61165, which supports higher swithcing frequency and higher current limit, and as simple as TPS61160.
hope this helps.
Other Parts Discussed in Thread: TPS61158 , TPS61169 , TPS61042 , TPS61165 , TPS61161 , TPS61160 , TPS61162 Hi TI LED Driver team,
I'm a little confused when I choose the single channel LED backlight driver, there are a lot of choices, such as TPS61158…
Other Parts Discussed in Thread: TPS61160 Hi
Could you tell me the sequence at TPS61160
Case1,
CTRL dimming
Vin,CTRL . start up and stop sequence.
Case2
CTRL(Always High)
VIN,CTRL,PWM signal.start up and stop sequence
Best regards,
…
Part Number: TPS61160A
Hi there,
I'm trying to power my TFT LCD display, which is rated at 500cd/m2 luminance rating. The only issue being that the screen clearly does not look as bright as it should be, which makes me think something is up with the…
Other Parts Discussed in Thread: TPS61160A , TPS61160 Hi
Wold you tell me below question about TPS61160A.
Question① Regarding the start up time.
PWM signal input to CTRL pin for variable light but TPS61160 Slow-Start time differs depending on the…
Hello Guoya,
There is limited discussion in the datasheet from the LM3429 for the PWM dimming. Others have looked into this issue and their discussion can be seen in the E2E post below. They were seeing some difficulty at 147Hz so the minimum on time…
Hi guys.
Recently, I owned proudly a New-Haven-Display which is called NHD‐4.3‐480272EF‐ATXL#‐CTP and I would like to run it with a PWM signal of the BeagleBoneBlack .
The following link shows the display documentation: www.newhavendisplay.com…
Well i am not good at hardware,should i go for TPS61160 or TPS61165?If you don't mind, Mostly both are same apart from led difference 6/10 & FET 26 V / .7A 38V / 1.2A ,switching freq. 600/1200(khz)
any specific reasons in choosing one over the other…
