Part Number: TPS61175
Dear TI Team
I have a question about the Current Iimit of TPS61175. In the data sheet of TPS61175, the minimum value of N-Channel MOSFET current limit is described as 3A, but if you look at the conditions, it is described as "FSW…
Part Number: TPS61175 HI! I am looking for developing variable frequency modulation (pulse frequency modulation) and pulse skipping modulation for light load conditions. I am planning to use an external controller like the c2000 TI launchpad for the above…
Part Number: TPS61175 Hi Team,
My customer want to know if the unencrypted PSpice transient model or TINA transient model of TPS61175 could be used in SIMetrix to simulate.
If could, could you provide a guide document for how to simulate?
Thanks,
Best…
Part Number: TPS61175 Other Parts Discussed in Thread: TPS25200 Hello,
I noticed that despite that in the datasheet it is specified that the soft start pin is getting discharged with 5k if the device is disabled, I did not observe this on our circuit.…
Hi JH,
I verified that TPS61170 can work in VIN = -15V, VOUT = -6V, IOUT = about 300mA(typ). Well, the max Iout at this condition is around 600mA.
To support the 1A Iout, TPS61175 can be the choice.
Regards
Lei
Part Number: TPS61175-Q1
Hi,
I have taken TPS61175-Q1 and made 2 designs. One with output of 12V and one with 24V.
In my board Ill be switching the output voltage between 12V and 24V by putting a resistor in parallel with one of the feedback resistor…
Part Number: TPS61175 Hi,
I am using tps61175 in my design. I am using this regulator for 5V to 12V conversion. I am using this regulator to drive an LED driver circuit for an LCD backlight. The LCD backlight will be controlled by a PWM signal. So the…
Part Number: TPS61175TPS61175 is used for 5V to 24V boost converter application. Unfortunately there seems to be an issue with the overcurrent protection mode which breaks our design.
Our schematic is based on the applications suggestion in the datasheet…
Part Number: TPS61175-Q1 i would like to increase the soft start capacitor in this design to 0.1uf to double the startup time and reduce peak startup current under rated load. present value of Css is 47nf, the only value allowed in the design (attached…
Part Number: TPS61175 I have revived question from customer.
In the data sheet, the ripple voltage is specified by the output capacitor of TPS61175.
However, it seems that the calculation formula and the measured waveform are different.
When Vin 5.5V…