Because of the Thanksgiving holiday in the U.S., TI E2E™ design support forum responses may be delayed from November 25 through December 2. Thank you for your patience.
Part Number: TPS61175-Q1 Other Parts Discussed in Thread: TPS61175 Tool/software: Hello Experts
I want to use the TPS61175 to design a boost circuit from 5V to 8.5V, the output current less than 200mA, and the output voltage cannot exceed 9V.
Please help…
Part Number: TPS61175-Q1 Tool/software: Dear TI team
Please tell me about the rating of the SW pin of the TPS61175QPWPRQ1.
I am concerned that there is almost no margin with the absolute maximum rating of the SW pin voltage being 40V against the recommended…
Part Number: TPS61175-Q1 Tool/software: Hello, Can you please review the design of TPS61175QPWPRQ1. I have attached a PDF file of the same.
PFA.
Awaiting for your valuable feedback
Thanks
TPS61175QPWPRQ1.pdf
Part Number: TPS61175-Q1 Other Parts Discussed in Thread: TPS61088-Q1 , LM5156-Q1
In TPS61175-Q1 need to set the output current as 3A.From the datasheet Iout is calculated from below equation,
From this it can be seen Iout depends on ILIM .So how to set…
Part Number: TPS61175-Q1 Hi team,
Does maximum duty ratio chance due to the Switching frequency?
If yes, are there any data of Maximum Duty ratio vs. Fsw?
Best regards,
Yuto
Part Number: TPS61175-Q1 I would like to know if temperature dependency is provided in the spice model of TPS61175-Q1, as I wanted to run the simulation at -40 degree Celsius and 150 degree Celsius. The simulation didn't work for me in these temperature…
Part Number: TPS61175-Q1 Other Parts Discussed in Thread: TPS61175 Dear team,
Could you please help review the schematic? Thank you!
TPS61175.pdf
In addition, they have a simulation on the webench as below,0.5A is typ. continuous current, and the max current…
Part Number: TPS61175-Q1 Other Parts Discussed in Thread: TPS61175 , , LM5157 Hi Team,
My customer want to use TPS61175+charge pump to realize 5.5V to -50V@20mA so as to replace LT8364.
Could you provide the reference circuit: TPS61175-Q1 With negative charge…
Part Number: TPS61175-Q1 I've tried using the unencrypted PSPICE model in my own circuit with my own PSPICE, and I've tried using TI's encrypted model and circuit and TI-PSPICE, but the result is the same. The simulation runs for 10+ minutes, indicates…
Part Number: LM2621 Other Parts Discussed in Thread: TPS61175 , LM5157-Q1 , LM5157 Tool/software: Hi Team, Customer is asking for a low cost device which is similar with LM2621, used in Sepic topology. Could you please help provide a suitable device here…
