Part Number: TPS61196-Q1 I'm using the TPS61196-Q1 LED driver, and I’m hearing audible noise from the capacitors/inductors. I’m not sure which component is the source.
I’m switching the PWM (low frequency) at 300 Hz. Measurements at Vout show a ringing…
Part Number: TPS61196-Q1 I built an LED driver to drive 2 LEDs. Each strip contains 33 LEDs. From the Led datasheet, I have the following characteristics:
For the driver IC, I chose TPS61196-Q1 and calculated circuit components values following the…
Part Number: TPS61196-Q1 Tool/software: Hello TI experts,
Could you please share formulae or reference for calculating power dissipation of external switching MOSFET? So we can select proper MOSFET (low SW loss and conduction) with better performance…
Part Number: TPS61196-Q1 Tool/software: Hi
Can use only four strings out of six?
if so, what should i do with the two spares?
Will the fault indicator be high all the time?
Part Number: TPS61196 Hi,
What is the difference between TPS61196 and TPS61196-Q1?
It seems that the recommended operating ambient temperature is different, but are there any other differences?
Best regards,
Part Number: TPS61196-Q1 Hi, TI support team
We are reviewing the TPS61196-Q1 product.
Power dissipation is shown as 1W at room temperature of 25 degrees. Please check if the PD value can be calculated as 1W even at an ambient temperature of 80 degrees…
Part Number: TPS61196-Q1TPS61196-Q1 drives 6 street lamp beads, 4 of which are connected with 16 lights in each road; The other 2 roads are connected with 17 lights each. Can they work normally?
Part Number: TPS61196-Q1 Five of them are used in tps61196-q1. If there is one street lamp with less beads than the others, can it work normally? (21 lights for 4 roads, 14 lights for 1 roads)
Part Number: TPS61196-Q1 Hi Team
There is a good new that we DIN TPS61196-Q1
Do we have data about " When TPS61196-Q1 triggers UVLO, what is the approximate time from triggering to turning off the backlight? "
This information is not seen on DATASHEET…
