Part Number: TPS61201 Tool/software: Dear Team,
Am planning to use TPS61201DRCT boost converter for my LoRa based IoT sensor card powered with AA batteries (2qty). What will be the maximum current it can source since its a fixed output version.?
Kindly…
Part Number: TPS61201 Heelo,
I am using TPS61201. However, there is a problem with the initial startup of the MCU due to the following problem. Please let me know how to solve this problem.
I am using a lithium primary battery with a 5F capacity supercapacitor…
Part Number: TPS61201 Hi Team,
Good day! Is it possible to get an autodesk eagle library footprint for exposed thermal pad for this device? Thank you
Best regards,
Jonathan
Part Number: TPS61201 Other Parts Discussed in Thread: TPS61200 Hello,
We are working on a self powered gas valve for water heater application. Thermopile works as a power source only. There is a bulk capacitor for peak current requirement but no primary…
Part Number: TPS61201 Hi team
i have a question.
In Pin Function table, It's said ''Must be connected to VAUX if not used''.
On the other hand, in the datasheet p1, UVLO pin is connected to Vin pin.
Why they are difference?
Best regards…
Part Number: TPS61201 Hi, I am designing a solar powered device that can power a micro-controller. I have a 3V 70mA solar panel that I want to connect to a TPS61201 to get a steady 3.3V output. I wanted to get the most output current from the TPS61201…
Part Number: TPS61201 Hi,
The audible noise occurs from inductor or capacitor when disabling the power save mode and using TPS61201 under the load condition of less than 5mA. Then, the output voltage ripple of 40mVpp can be observed at a frequency of several…
Part Number: TPS61201
My project is harvesting the radio frequency energy and store it in a capacitor. After the capacitor is a TPS61201. According to the datasheet, the input range is 0.3-5V, when I using a 1.5V 3A battery to test the booster, the output…
Part Number: TPS61201 Other Parts Discussed in Thread: BQ24075
When I disable TPS61201DRC, power from VOUT turns off, but chip continues to warm up and actively drain the battery. When enable , VOUT have 3.2v and all is fine. What could be the problem…
Part Number: TPS61025 Other Parts Discussed in Thread: TPS61201 , Hi, I am using the TPS61025EVM to power my design but saw a post by one of your engineers about possibly switching to another Boost Regulator because of tantalum cap. I saw this one and would…