Part Number: TPS61222-EP I'm considering using the above part number boost converter, but am concerned about the output noise at low output currents. In the application, there will be two modes of operation, one at 15 uA, and the other at 150 uA.. The…
Part Number: TPS61222 Other Parts Discussed in Thread: TLV61220 , TPS61220 Hi Team
I'm looking to use this TPS61222 boost converter. There is this layout guidelines where it mentions it will pose stability problems.
1. Is it possible to explain what…
Part Number: TPS61222
I'm using this IC (TPS61222DCKT) to boost the battery voltage (3.3V to 4.2V) to +5.5V on the output. The idea is to power an LDO regulator for 5V and then power some low power sensors.
The problem is that in the output…
Part Number: TPS782 Other Parts Discussed in Thread: TPS61222 , TPS7A03 , TPS7A02 Hi, Support Team
A circuit was formed by combining the TPS78230 and TPS61222.
However, a problem has occurred, so we will contact you as follows.
First of all, please review…
Part Number: TPS61222 Hi TI Engineers,
I want to connect the the ENABLE pin of TPS61222 to uC. What is the internal pull down resistor value of EN pin? Please tell me the input / output current of the EN pin. Since it is a logic terminal, I think it has…
Part Number: TPS61222 Other Parts Discussed in Thread: TPS61099 Hello TI Team,
Please find the attached schematic of "TPS61222DCKR" Boost converter and review the same.
Input : 3.8V
Output : 5V/0.4A
Part Number: TPS61222 Hi,
I plan to use the TPS61222 in an energy harvesting application that requires a 5V rail with an extremely low power consumption. The 5V rail will be used to drive a CMOS based analog switch whose input will be ~5V. The current…
Part Number: TPS61222 Other Parts Discussed in Thread: TPS54J060 , TPS22951 Hi, Team,
Now my customer is searching buck DCDC part with the latch protection at overcurrent(Vo shorted to GND).
The spec requested of IC is;
VIN range= max 6V, Programmable VO…
Part Number: TPS61222 Dear TI-fellows,
I'd like to use a TPS61222 on my PCB to allow for charging with 0.7V solar panels. Currently, the TPS61222 is connected as follows:
As inductor, I am using a 2.2µH with 320mA current rating and 1Ohm resistance…
Part Number: TPS61222 Other Parts Discussed in Thread: TPS61099 Hi, I am designing a circuit and I used the TPS61222 Boost Converter. I feed in the input of the converter with a Li-Ion 4.2V battery and I have a couple of 5V sensors connected on the output…