Part Number: TPS61291 Other Parts Discussed in Thread: TPS61099 Hello and thank you for assisting with this test.
The highest voltage expected on the input is 3.2V, It will only be at this voltage for a short while as the product operates, it will soon…
Part Number: TPS61291 Hello Team,
My customer would like to operate this in constant boost mode. The boost chip is configured for a 3.0V output but the input voltage will be about 3.2V until it drains down below 3.0V. The converter operates cleanly when…
Hi Jonathan,
I tested the EVM on bench. It shows some leakage on input side. Internal control circuitry needs to have normal input also EN/BYP should be actively terminated. If VIN and EN/BYP is floating, device does not know the state of the operation…
Part Number: TPS61291 Hi Sir,
We are using TPS61291 in our pro duct design, but we didn't find the package size information in the datasheet . Can you provide this information?
Thanks,
Best Regards
Part Number: TPS61291 Hi Sir,
I am in charge of a IoT project. I plan to use TPS61291 for main power supply.
Just wondering the current consumption, would you please let me know the maximum output current of the following condition :
VIN : 3.0V ~ 3.6…
Part Number: TPS61291 I am currently using this device in my design.
TI do not have stock available.
Are there a drop in replacement component?
Are there a replacement component that is and will be available?
Thanks
Part Number: TPS61291 Other Parts Discussed in Thread: CC1352P Hello,
We are going to use TPS61291 in our design. Please help me with the following question:
How much time does it take to switch from Bypass to Boost mode and vice versa? The EN/BYP signal…
Part Number: TPS61291 In one of my projects, I am using buck boost converter from TI # TPS61291.
My power supply voltage is below 2.7V & When I am going to enable boost mode by giving high to enable pin through GPIO (from controller). Its not going in…
Part Number: TPS61291 Hi!
I am working on TPS61291 implementation in our schematics and as far as we understand the EN/BYP must be either LOW or HIGH at ALL times. Our product is using a battery as a power source and when it is inserted - MCU takes time…
