Search tips
Showing 52 results View by: Thread Post Sort by

  • TPS61376: TPS61376 OVP Behavior Under IC Failure Modes for IEC 61508 Consideration

    Part Number: TPS61376 Hi team, I have a question regarding TPS61376. One of my customers is aiming for IEC 61508 certification and is concerned about the device behavior when the IC itself is damaged or fails. Specifically, can we say that,…

  • TPS61376: TPS61376-Design Calculation sheet required

    Part Number: TPS61376 Other Parts Discussed in Thread: TPS61287 , TPS61377 Hello Team, We are designing the boost converter circuit with below parameters: VIN: 5V VOUT: 20V, 0.5A(Nominal Current), 1.6A(Peak Current) Please share the calculation…
    • Answered

  • TPS61376: TPS61376 output capacitance limits

    Resolved
    Part Number: TPS61376 Tool/software: The datasheet for the TPS61376 gives the recommended max output capacitance at 2000uF. Due to the pulsing nature of my load, I have found that I need 4700uF or more. Is there a reason I can't use 4700uF or more output…
    • Resolved
    • Answered

  • TPS61376: TPS61376 alternatives with average input current limit?

    Resolved
    Part Number: TPS61376 Tool/software: I'm been looking at using the TPS61376, but I'm wondering if you have other boost converters with average input current limits.
    • Resolved

  • TPS61376: TPS61376 PSICE TI simulation Error

    Part Number: TPS61376 Other Parts Discussed in Thread: TPS55289 Tool/software: Dear TI experts. When simulating with reference circuit from datasheet , the following error occurs . Please check what the problem is. Unfortunately , I can ' t attach…

  • TPS61376: System drains too much current and doesnt get to the desired voltage when load is connected.

    Part Number: TPS61376 Hello, kind regards. Please, i would like to get TI assistance to determine the source of some trouble we are getting with the TPS61376RYHR, its intended to boost the voltage from a battery of 12V 8000mAh to 18V max 1A output. Please…

  • TPS61376: Parts suggestion for design Audio power supply with positive and negative output by single TI chip

    TI Thinks Resolved
    Part Number: TPS61376 Hi Ti team, I would like to replace the existing XL601x PMIC IC by TI. I am concerned that the design may overstress the Switch's max voltage and current, may I know the feasibility or recommend a better TI part? Thanks a lot…
    • Answered

  • TPS61376: Schematic review

    Resolved
    Part Number: TPS61376 Tool/software: Please suggest if any changes are required, especially the compensation network. Input: 19-21V DC Output: 24V DC, 1.875A I have included the TPS61377X calculator tool with my inputs for the compensation network…
    • Resolved

  • TPS61376: any Q-grade plan or any Q-grade solution could replace TPS61376?

    Part Number: TPS61376 Other Parts Discussed in Thread: TPS61378-Q1 , AM62P Tool/software: Hello expert, May we know if there is any Q-grade plan or any Q-grade solution could replace TPS61376? thanks a lot! Best regards, Ann Lien

  • TPS61376: What's VCC ability and it's behavior while EN is off

    Part Number: TPS61376 Hello, What's VCC behavior when EN is off? Will VCC off when EN is off? What's VCC 4.8V regulation tolerance? 4.8V is typical. How about min and max voltage? What's VCC output current ability? I plan to use VCC 4.8V to drive…

Didn't find what you are looking for? Post a new question.