Answered

• RE: TPS62006 info about components

  

  Chris Glaser

  Resolved

  This is quite an old IC to be using. There is a detailed inductor selection section in the D/S. The DC current of the inductor needs to be above your output current for any buck converter.

  • over 9 years ago
  • Power management
  • Power management forum
Answered

• TPS22953: TPS22953 Power good output low voltage

  

  Kalle Gronvik

  Resolved

  Part Number: TPS22953 Other Parts Discussed in Thread: TPS63020 , TPS62006 Hi, I can't find any specification of the drive capability of the TPS22953 PG pin so what is the output level for some specified current? Many of TI's devices (e g TPS62006, TPS63020…

  • Resolved

  • over 6 years ago
  • Power management
  • Power management forum

• TPS61020: no load current is too high

  

  Gama D

  Part Number: TPS61020 Hi, i am using this chip with 2 AAA cell and trying to run a xbee with it. but at no load, this is consuming over 10mA which is far exceeding than what's mentioned in datasheet. According to the datasheet, it should be around 50uA…

  • over 8 years ago
  • Power management
  • Power management forum

• TPS61099: TPS61099x -One cell Battery boost -up to 1 AMP

  

  Reza Alinejad

  TI Thinks Resolved

  Part Number: TPS61099 Other Parts Discussed in Thread: TPS61029 , TPS61021A , Hello, any offer,advice for boosting 1-cell Alkaline Battery to 3 to 3.6 volt that can handle minimum load 500mA and goes up to 800mA ? thanks

  • over 7 years ago
  • Power management
  • Power management forum

Didn't find what you are looking for? Post a new question.