Part Number: TPS62162-Q1
Hi All,
How to understand the enable threshold of TPS62162-Q1, why the VEN_H min value is smaller than the typ value, and the VEN_L max value is smaller than typ value?
Does this mean that typically 0.6V can turn on most…
Part Number: TPS62162
Tool/software: WEBENCH® Design Tools
I want to see a reference design that will allow for either LIPO or 12VDC input to a TPS62162. Webench will not allow lower than 4V input. Datasheet says the chip will handle down to 3. Why…
Part Number: TPS62162 I have been having odd problems with my two VREGs, this is related to the post I made previously. Anyways, my layout was not the problem, which was a theory I was little skeptical of given the symptoms. I assembled my new board and…
Part Number: TPS62162 Other Parts Discussed in Thread: TPS62161 , Hello,
I have a 3.3V TPS62162 voltage regulator. It is sequenced by having a 1.8V TPS62161 voltage regulator connected to the Enable Pin. The power sequencing works correctly on power up…
Part Number: TPS62162-Q1 Other Parts Discussed in Thread: TPS62162 Hi team,
I have a question about TPS62162 EN input. As the d/s write, when EN input<0.3V,it will not work, when EN input>0.9V,it will enable. I want to ask if we have done some test about…
Part Number: TPS62162 Other Parts Discussed in Thread: TPS62163 , I am currently powering the the SAMC21 in dual power supply mode with the 5V TPS62163 and the 3.3V TPS62162, the 5V IC is working fine, however the 3.3V IC is outputting 3.66V(very stable…
Hi Greg,
Was the write up you read explaining how to power the CC3235 EVM section "2.5.2 Battery Powering CC3235 LaunchPad Kit" from the CC3235 SimpleLink Wi-Fi LaunchPad Development Kit Hardware ?
Are you using the equivalent of a 6v battery on…
Hi Aaron,
Yes, those are the low-side FET body diode drops that you see on the SW node. The actual value may be different slightly but yes the nature of the SW node waveform is accurate. Also, these will not damage the IC. See https://www.ti.com/lit/an…
Part Number: TPS62901 Other Parts Discussed in Thread: TPS62162 , I currently use the TPS62162 and I don't need any external resistor there to set the output voltage to 3V3.
When looking at the datasheet of the TPS62901 as an alternative part (due to…