Part Number: TPS62560 Tool/software: Hi team,
Could you teach me how to enter/exit DCM mode in TPS62560?
I understand inductor current = 0 is threshold roughly, but I think there are hysteresis or time to determine.
Regards,
Youhei MIYAOKA
Part Number: TPS62560 Other Parts Discussed in Thread: TPS628510 , TPS628301 Hi team,
My customer has question about output FET ON timing.
In the output FET stage, they don't think that the FET turn on at the same time, but how long is the dead time…
Part Number: TPS62560 To Whom It May Concern,
Our products use the TPS62560 part to convert 5V to 3.3V.
Using different multipliers for resistors and capacitors against data sheet.
Could you let me know the phase margin?
And if you have any advice…
Part Number: TPS62560 Hi team,
My customer want to know current limit in datasheet.
1. 7.1 Absolute Maximum Ratings shows Peak output current is internally limited.
Is this limit fixed value? If so, please teach me.
Or is this limit value the…
Part Number: TPS62560 I understood that the dead time when ON is a few ns.
Is it the same time when OFF? (Are the setting times for ON and OFF different?)
Is the design value 2ns(typ)?
Does the fall time of the waveform and the recovery time of…
Hi Emmanuel,
Even we modified the firmware and seems like solved the problem, but because we are planning to build another 100 units with TPS62560 recently so we want to 100% confirm what is the root cause. Therefore, could we send 1 pcs failed board…
Part Number: TPS62560 Dear E2E member,
Did TPS62560 have OVP function?
I don't find the any OVP description on datasheet.
If not, could you kindly let me know the reason?
Thanks!
Part Number: TPS62560 Hello,
I am using TPS62560DRVR in one of our designs. The device is observed to go bad in nearly 12 board out of 50 assembled for proto build. In all the faulty boards the SW pin to GND resistance is observed to be <30 ohms. The…
