Part Number: TPS62806 Tool/software: Hello,
Our customer has a question about TPS62806 output voltage VOUT temperature characteristcs in low temperature.
As I understnad that VOUT temperature characteristics depends on the bandgap voltage, so I believe…
Part Number: TPS62806-7-8EVM083 Hi
Please provide the CE/EU Declaration of Conformity for this product.
The product is CE-marked, however, the CE/EU Declaration of Conformity is not available on the T.I website.
Thanks
Part Number: TPS62806 Hi team,
For TPS62806, for the VSEL resistor for 0.6V output voltage, customer only get 56kohm 1% resistor in their AVL, while in our datasheet it's 56.2kohm 1% for 0.6V output voltage, they would like to check could they use this…
Part Number: TPS62806 Other Parts Discussed in Thread: LMV7275 , I have the following schematic The problem is with R140 and R141 changed to 0 ohms and a common mode resistance of 57k (typ) in the comparator the buck regulator APPEARS to charge. It does…
Part Number: TPS62806 Hello,
We ordered from Mouser TI#TPS62806YKAT; as per the specs available these parts should be marked with a J but the ones we received are marked with a K. Mouser's answer was "TI reserves the right to upgrade their part marking…
Hello Lisa,
Thank you for the information. Please find the efficiency measurements of TPS62808, Vin =3.6V, Vout=3.3V, temp =25 °C.
The measurements are performed by using EVM( TPS62806-7-8EVM083 Evaluation Module )
Thank you & regards,
Moheddin. …
Hi Yoav,
Have you checked our TPS6280x family?
Please have a look at the datasheet: https://www.ti.com/lit/ds/symlink/tps62806.pdf?
It meets your specifications, but please confirm that the voltage overshoots during load transients meet your requirements…
Hello Andreas,
Thank you for coming to us with your queries.
There is no Pspice model for the TPS62625 model since it was developed more than 12 years ago. In any case, you can consider our newer device (TPS62801). It has a solution size of 5.7 sq. mm…
Hi Daniel! I hope you're doing well.
The TPS62806 supports Vouts down to 0.4V. If you need lower, you need to feed a voltage into the FB pin on a device like TPS62821/5. I will email you some preliminary documents on this topic. Here are 2 older ones…
