Part Number: TPS62913 Tool/software: Does anyone have any reliability/MTTF/MTBF/FIT data for TPS62913RPUR. I am unable to find it on TI MTBF/FIT estimator as it says part number not found. Thanks.
Part Number: TPS62913 Other Parts Discussed in Thread: TINA-TI Tool/software: Hi,
for evaluation purposes I want to simulate the TPS62913 in TINA-TI. What I have to do to simulate this device? How can I add the the PSpice model from the homepage?
Thank…
Part Number: TPS62913 Other Parts Discussed in Thread: TINA-TI Tool/software: Hi,
I open a Webbench Exported design for the TPS62913 and did some modification. I want to simulate a transient analysis with 5ms and the simulation need very very long time…
Hi Ramgopal,
Thanks for your feedback! I am just curious, if this rail is from +5V to -6V (Buck configure as IBB) and then -6V to -5V with LDO. Why not just use one TPS62913 and configure it as IBB to generate -5V? TPS62913 target for low noise and low…
Part Number: TPS62913 Hi,
I am using TPS62913 in my design and getting DRC error after connecting S-CONF to GND.
I have assigned S-CONF Pin-type is output in my current design.
Can we assign S-CONF Pin-type is power to avoid DRC error?
or We can connect …
Part Number: TPS62913-IBB-EVM With reference to document SLVUC22, what are the components I should change on the TPS62913-IBB-EVM board for the following usage:
Vin: +5.2V
Vout: -3.3V for 300mA load.
Regards,
Angie
Part Number: TPS62914 Other Parts Discussed in Thread: TPS62913 , TPS62916 Tool/software: Hi,
how do the two devices compare in terms of radiated emissions?
say both are operating at 3.3V and 3A and the same switching frequency.
the question more specifically…
Hi Hans,
Add more comment from my side. We have tested the TPS62913 with duty cycles outside of the 45%-55% limits in the datasheet and have not seen any issues. An example of the device operating with an external sync with 70% duty cycle is shown below…