Part Number: TPS62932 Hi Team,
I am using TPS62932DRLR in a 24V input to 5V output design (1A load). I am facing a critical issue where:
Some boards fail or get damaged during first power-up
Some boards start successfully
Below is the schematic…
Part Number: TPS62932 I am designing a circuit using
TPS62932 buck regulator and want to confirm the feasibility of my Enable (EN) pin control logic.
The proposed control scheme is as follows,
Active low/idle state: The EN pin will be tied to GND…
Part Number: TPS62932 Tool/software: Hi Sir,
here is customer test setup for TPS62932 as below,
using external power supply CH2 to touch VOUT for trigger OVP.
we got SW pin have OVP behavior but VOUT only 4.3V, it not match 115% OVP threshold…
Part Number: TPS62932 Hi,
We need guidance to perform the following tests in buck regulator of Manufacturer Part number: TPS62932. Kindly share the detailed procedure.
Input Voltage = 20V
Output Volatge = 2V
Maximum Output Current = 5mA
1. Input…
Part Number: TPS62932 Tool/software: Hi Team,
Can you help to check whether TPS62932 can fulfill the following requirement? Thanks.
Vin=12V-18V
Vout= -9V
Iout= 300mA/600mA
Efficiency>80%
BR.
Frank
Part Number: TPS62932 Hello TI Support Team,
I am experiencing an issue with a design based on the TPS62932 buck converter.
The schematic and layout can be found in page 2 of the attached design files.
Observed behavior:
When enabling the converter…
Part Number: TPS62932 Dear Support Team,
We have confirmed that an undershoot of ≤ –3.0 V occurs during the falling edge under maximum load conditions. At the same time, we have verified that the pulse duration is 10 ns or less (please refer to the…
Part Number: TPS62932 Tool/software: Dear Sir/ Madam
Good day, I am Noli from Tokyo Electron Device.
We purchase 400pcs of TPS62932DRLR from TI store (#T05736035) for our customer's trial production,
however there occured a soldering probem while…
Part Number: TPS62932 Hi team,
When I connected RT to GND under the following conditions and set it to 1.2MHz, it became 833kHz.
Vin:12V Vout:9V L:10uH RTpin:GND
Are there any possible causes?
Best Regards, Ryu.
