Part Number: TPS62A02 Hi Team,
Could you please help test efficiency of TPS62A02 in below condition?
Input: 3.8V
Output:1.8V
Load: No load / 10uA/ 20uA/ 300uA/ 1mA/ 5mA/ 10mA
Thank you,
Yishan Chen
Part Number: TPS62A02 Hi team,
My customer would like to reduce output capacitor smaller than 10uF to optimize the cost.
Would it be possible to use 8.2uF or 6.8uF output capacitor?
Is it determined by the loop stability?
Best regards, Kazuki…
Part Number: TPS62A02 Hi team,
TPS62A02 have both HS and LS current limit. But I don't think LS limit can work because HS limit will be always activated before LS limit works. Why is LS limit 4.2A? I suspect this is miss print because 4.2A LS limit…
Part Number: TPS62A02A Hello team,
Can you provide linear-log graph for Figure 8-11 as same as Figure 8-10 to compare same condition?
Best regards,
Shotaro Sakai
Part Number: TPS62A02 Hi
We're doing some board design with this part and have the following questions.
Since we are not using the Power Good (PG) pin, is it still necessary to populate R4 ( 499 kohm ) ?
Regarding the layout, should C3 be placed…
Part Number: TPS62A02A Other Parts Discussed in Thread: TPS62A02 , Hello, we have an application where we are using several TPS62A02 / TPS62A02A dcdc converters. We have found that one rail in particular appears to have tones around 600kHz. We have tried…
Part Number: TPS62A02A Other Parts Discussed in Thread: TPS62A02 Hello TI Teams
I am currently designing a power solution using the TPS62A02 and have a question regarding the selection of feedback (FB) resistors.
Initially, I selected a 100kohm resistor…
Part Number: TPS62A02 Tool/software: Hello guys,
One of my customers is considering evaluating TPS62A02DRLR for their new products.
At this moment, they have the following questions. Could you please give me your reply?
Q1. They want to use a feed…
Part Number: TPS62A02 Tool/software: Hi,
I'm using the above part for our module design. One question I've is regarding the active discharge switch in the functional block diagram. Can I confirm that this switch is automatically enabled when EN=0? …
