Search tips
Showing 46 results View by: Thread Post Sort by

  • TPS63810: what does IIH/IIL means?

    TI Thinks Resolved
    Part Number: TPS63810 Hi Team, my customer want to use GPIO to control Vsel and found there are below parameters? does it mean the output current capablity of GPIO should be above the value to drive VIH or VIL ? Thanks. For example, if GPIO has 10uA capability…

  • TPS63810: parasitic parameters requirement for Vin and Vout

    TI Thinks Resolved
    Part Number: TPS63810 Hi Team, is there specific parasitic parameters requirement for Vin and Vout ? Thanks. BRs Given

  • TPS63810: TPS63810's bonding wire material and chip pin material.

    Part Number: TPS63810 Hi Team, Can you provide the bonding wire material and chip pin material of TPS63810YFFR_DSBGA15? Thanks. Regards, Charlie

  • TPS63810: TPS63810 -Input voltage range

    Part Number: TPS63810 Hi Ti team, No load test TPS63810 startup voltage, found that the lowest startup voltage is 2.5V, specification is 2.2V.( Not in the EVM），Please help to confirm，Thanks！

  • TPS63810: TPS63811

    Part Number: TPS63810 Using buck-boost converters (TPS63810 or similar) in device w/4.8v battery and two 3.6v LEDs. Tested, works. But device needs to illuminate only in darkness. Using LDR photosensor setup, TPS63810 does not work. Is there solution…

  • TPS63810: Power management forum

    TI Thinks Resolved
    Part Number: TPS63810 Using buck-boost converters (TPS63810 or similar) in device w/4.8v battery and two 3.6v LEDs. Tested, works. But device needs to illuminate only in darkness. Using LDR photosensor setup, TPS63810 does not work. Is there solution…
    • Answered

  • TPS63810: power consumption when no load and FPWM mode

    Resolved
    Part Number: TPS63810 Hi Team, just want to check the power consumption ( Iq) when no load and in FPWM mode. Thanks. BRs given
    • Resolved

  • TPS63810: TPS63810 output drops below 5.0V at iridium modem

    Part Number: TPS63810 Dear Team, we are having an issue with the output power of TPS63810 when attached to an Iridium SBD9603N modem (Please see specifications attached on page 21). This modem needs 5.0 V and up to 1.3A peak power, and randomly the output…

  • TPS63810: if TPS63810 has bypass mode when Vin=Vout

    TI Thinks Resolved
    Part Number: TPS63810 Hi Team, Just want to check if there is bypass mode when Vin=Vout. in datasheet, I see when Vin=Vout, it changes between buck, boost and Commutate phase. Only in commutate phase, it is similar with bypass mode. But it cannot work…

  • TPS63810: Inductor choice of TPS63810

    TI Thinks Resolved
    Part Number: TPS63810 Dear TI, In the datasheet, TI strongly recommend an 0.47uH inductor to be chosen for TPS63810. Here we want to check with you if we can use an 1uH inductor？ Is there any risk, such as loop stability? In our design, Vin is the voltage…

Didn't find what you are looking for? Post a new question.