Part Number: TPS65130 Hi team,
I have two question about changes from Rev.D to Rev.E.
- Changed ESD HBM specification from "±2000" to "±1000"
What is the reason for changing to 1 kV? Was 2 kV a typo?
• Changed text string…
Part Number: TPS65130 Other Parts Discussed in Thread: TPS65131
Hi Expert,
I have some questions regarding current limit in TPS65130. Customer had drew current over current limit which is 800mA and IC didn't seem to be switching as it exceeded limit. However…
Part Number: TPS65130 I have built a prototype PCB with TPS65130, but I am seeing a lot of noise on the positive rail.
Since it powers analog audio circuits, I need to reduce the noise as much as possible.
Input is 5V from lab supply, output is +/-12V…
Part Number: TPS65130 Other Parts Discussed in Thread: PSPICE-FOR-TI , TPS65135 , , TPS65133 I'm trying to design a split-rail dc/dc converter for measurement system. These parts fit my needs best due to low PCB area. However support in Webench is limited…
Part Number: TPS65130 Hi team,
My customer used TPS65130 to design "VIN=3.3V and Vout= +/- 10V." Below is their SCH, and refer to our TI design.
But the board test result is that "VCC3.3V=3.1V , P10V=9.7V , N10V= -0.4V". May I know why N1…
Part Number: TPS65130 Hi all,
i have a question on the voltage deviders for FBN and FBP.
The resistor values are quite high (up to 1 meg etc). Is that needed?
Can i use lower values that provide the same ratio?
Example: i am using 150k / 13k on FBP and…
Part Number: TPS65130 Hello, We have designed TPS65130 regulator circuit for +/-15V regulation. During power up we are seeing that -15V startup seems to be correct but +15V is not correct as we are seeing step from +5V after enable and after around 12ms…
Part Number: TPS65130 HI team
We use TPS65130 to generate ±15V from a 5V supply, but we found that TPS65130 can output correctly with no load,but can't output with even 10mA load.
We check the SW point of positive and negative as the figure…
Part Number: TPS65130 Other Parts Discussed in Thread: TPS65131 hello,
I have two questions about the specifications of the TPS65130.
No1 There is MIN "Vin + 0.5V" in VPOS of 6.5 Electrical Characteristics. For example, when Vin = 5V, can + 5V…