Part Number: TPS65150-Q1 Dear Team,
Could you please help check below schematic?
Input voltage is 3.3V, output LCD_AVDD=11.6V, 80mA. VGH = 22V, 0.6 mA. VGL = -9V, 0.6 mA.
Thanks & Best Regards,
Sherry
Part Number: TPS65150-Q1 Hi Brigitte,
My customer asked urgently whether the TPS65150-Q1 can delay between VIN and V(VS= AVDD) as diagram below. Is it possible to delay between them? And please explain in detail how to do delay using the isolation switch…
Part Number: TPS65150-Q1 Dear team,
In the datasheet , there are two kinds of power on sequence as below. Why are they different? Why does the external mosfet impact the power on sequence?
Thanks & Best Regards,
Sherry
Part Number: TPS65150-Q1 Other Parts Discussed in Thread: TPS65150 Dear,
our client use TPS65150-Q1, but we find the if R209 29.4k ohm change to 39.2 ,VDDA output voltage is 3V ,not 9V.
but we just change R209 39.2k ohm to 29.4K ohm, output voltage…
Part Number: TPS65150-Q1 Hi, Team:
Can you help to check attached schematic and advise if any questions?
Just reminder: The Feedback resistor value is very low compare with datasheet suggestion.
Hello Lawrence,
The TPS65150-Q1 device detects a fault condition and shuts down if the boost converter output or either of the
charge pump outputs fall out of regulation for longer than the fault delay time td(FDLY). Furthermore, the output fault detection…
Part Number: TPS65150-Q1 Dear team,
I see the recommendation values, but my input voltage is 4V, and my boost output is 11.6V. How should I choose the Rcomp and Ccomp. Could you please tell me the how to compute these two values?
Thanks & Best Regards…
Part Number: TPS65150-Q1 Hello
When the output load suddenly increased,the input current will inreased too, but why find nagative current ? nearly - 200mA
Part Number: TPS65131-Q1 Other Parts Discussed in Thread: TPS65150-Q1 Hi team,
would you please suggest if you have any EMI test result of TPS65131-Q1 or TPS65150-Q1 based on EVM or reference design? we wish to use data to convince end customer that…
