Part Number: TPS6521815 Hi, TI expert
- Application : optometry equipment
The customer is using XC7Z020-1CLG484I (Xilinx) for the above application. There is a circuit of power used for DDR3L and DC-DC currently in use, and we received a PMIC recommendation…
Part Number: TPS6521815 Tool/software: Hi,
We are currently considering a new power supply architecture for an FPGA board and would like your recommendation for a suitable TI power management IC that meets the following requirements.
[Background &…
Part Number: TPS6521815 Hi Team,
As we are using TPS6521815 PMIC for powering Cyclone V FPGA. So, we are planning to do power Integrity analysis for that we need an information from your side.
What is the ROUT and LOUT of the Pin L1, L2, L3, DCDC4…
Part Number: TPS6521815 Other Parts Discussed in Thread: TPS53631 Tool/software: Dear Team,
Do you have Intelli-PhaseTM Solution parts that can replace MP87440 and MP87420?
A cross-reference search couldn't yield any part numbers.
BR,
Part Number: TPS6521815 Tool/software: Hi team,
Customer would check, do we get PMIC could generate following power rail for uOLED screen?
Vin = 3~5V
Thanks and best regards,
Will
Part Number: TPS6521815 Other Parts Discussed in Thread: TPS65218D0 , TPS51206 , TPS65218 , TPS51200 Hello,
Hope you are doing well,
We are using TPS6521815 PMIC for powering Cyclone V GX with DDR3 memory, having few queries with sequencing and configuration…
Part Number: TPS6521815 Other Parts Discussed in Thread: BOOSTXL-TPS65218 , TPS65218D0 , MSP-EXP430F5529LP , IPG-UI , USB2ANY , TPS65218 , TPS65023 , MSP430F5529 Tool/software: Hello,
I am working on a design to power a Zynq 7000 series FPGA. As I understand…
Part Number: TPS6521815 Other Parts Discussed in Thread: TPS65218 , USB2ANY , IPG-UI Tool/software: Hi team,
Our customer is considering installing a blank TPS65218 and then programming it on-board. If VIN_BIAS is set to 5V and USB2ANY is connected…
Part Number: TPS6521815 Hi, I'm Taka.
I use the PWR_EN pin for power up.
The PWR_EN pin has a deglitch circuit and the deglitch time is typ 10ms.
What is the maximum and minimum deglitch time?