Hi Leif,
We have not seen an update from you for one month, so I assume the questions are answered and the issue is solved.
If you don't have any further questions, can you please close the thread by clicking on resolved. Clicking the Resolved Button…
Part Number: TPS65235 Hi,
Could you tell me the worst case power consumption in certain modes of the TPS65235 and how this could be calculated.
e.g. 12V input/ 18Volts output/ at 600mA load/ with diseqc. 140mΩ power MOSFET running at 1 MHz
Thanks…
Part Number: TPS65235 Hi,
I have been looking at designing an LNB which is controlled by DiSEqC signalling and found this IC. From reading the datasheet it appears that IC provides a +13V/+18V signal with the 22kHz. Is it also possible to use this IC…
Part Number: TPS65235-1
Hello,
Our customer has a question if TPS65235-1 has a potential issue in his application.
In his application, 12.7V boost input voltage is dropped to 12.4V for 10ms then back to 12.7V, while it works 19V VLNB. Even though he…
Part Number: TPS65235
Hi
May I know the main difference between TPS65235 and TPS65235-1? By comparing the both datasheets, it seems like the only difference is the support of FCCM.
I have two questions:
If we are not using FCCM mode, then TPS65235 could…
Part Number: TPS65235 Hello, we are facing a problem with the voltage amplitude of the DiSEqC signals. Is there a way to increase it above 750 mVpp? We would need this feature because a few costumers have some multi-switches that need a amplitude up to…
Part Number: TPS65235 In comparison table from the link below Max Iout of TPS65235 is 0.65A and TPS65235-1 is 1A.
However, both TPS65235 and TPS65235-1 datasheet shows Iout max is 1A.
We would like to know which one is correct for TPS65235?
if both TPS65235…
Part Number: TPS65235 Hi, TI expert.
A customer has an inquiry about the Fall time of SCL signal of I2C Interface of TPS65235.
If you look at the datasheet, the MIN spec is 20ns.
However, if you actually measure it, it is measured as 12.859ns. (see SCL…
Part Number: TPS65235 Hello, we currently have a case of using TPS65235, and the customer has reported a problem: When 22K is turned on, the cable detection mechanism of TPS65235 will cause false positives. The simple schematic diagram of our board is…