Part Number: TPS65265 Tool/software: Hello,
I have a design based on the TPS65265 EVM, with 1V, 1.8V, and 3.3V outputs. All three outputs appear to be unstable under load, with oscillations at various frequencies in the 75kHz to 150kHz range, depending…
Part Number: TPS65265 Other Parts Discussed in Thread: TPS65279 , Hello Experts,
Is it possible to club together the 3 outputs of this chip to get 10A output?
In what all combinations can the three outputs be clubbed together to get more current output…
Part Number: TPS65265 Other Parts Discussed in Thread: TPS563252 , TPS563240 Hi team,
I have a customer who needs an alternate for the XC9263A75CMR-G. The footprint would need to be around the same, which is in a SOT-25 and a 5-pin configuration of Vin…
Part Number: TPS65265 I am using TPS65265 with Vin=12V to get triple output voltage of 3.3V, 5V and 3.7V. Help me in choosing DC-DC loop compensation values for each of the output channel. schematic of same is attached. TPS65265.pdf
Hi Felix,
We have not seen an update from you for one week, so I assume the questions are answered and the issue is solved.
If you don't have any further questions, can you please close the thread by clicking on resolved. Clicking the Resolved Button…
Part Number: TPS65265 Hi,
I am using TPS65265RHBR, triple Output buck, to have 5V, 8V and 3V3 rails. I was wondering if I chose the right component for the compensation pin. The design was based on the eval board as well.
Any recommendation would be highly…
Part Number: TPS65265 hi team:
i want to quote another trend for more discussion. Previous link:: https://e2e.ti.com/support/power-management-group/power-management/f/power-management-forum/1113645/tps65265-enable-function-mode-uvlo-setting-logic
In these…
Part Number: TPS65265 hi team:
My customer use TPS65265 device and feedback that there is no output of BUCK1/2/3. The SCH and the waveform of PVIN and EN is as below.
As i check the spec, the customer try to float the mode pin, and it works normally.
…
Part Number: TPS65265 Hi E2E Team,
Can you please explain, what "Mode"-level should be used regarding the automatic and external power-up sequencing? Within the datasheet (table 2) there are some states within the automatic power-up where "Mode…
