Part Number: TPS65276V Tool/software: Hello.
I use SMPS TPS65276VR (QFN package). It is connected according to the recommended circuit, the output voltages are 3.3V and 5V, I do not use the I2C bus. Two 10K pull-up resistors are fitted on I2C.
…
Part Number: TPS65276V Tool/software: Hello E2E Desgin Support team,
I have used a TPS65276V in one of my design to generate 2 regulated DC outputs
The internal V7V LDO is currently decoupled with a 1µF ceramic X5R 25V capacitor corresponding to the…
Part Number: TPS65276V Other Parts Discussed in Thread: TPS65279V , Hi team,
Due to the shortage problem, therefore, customer has few question about the difference between TPS65276v and TPS65279v as below.
They would like to know whether TPS65276v…
Part Number: TPS65276V Dear friends,
I'm going to use this part (TPS65276VRHH) and I made calculations based on the data sheet (including power dissipation).
But I didn't found output voltage span information inside data sheet.
This information…
Part Number: TPS65276V I am working on a capacitance loading calculation for a card. We use the TPS65276VDAPR. In the data sheet, only a maximum figure of 400pF is given. Is there a typical value for the part?
Thanks
Dave R
One common approach is to use an LDO follower for your low noise requirement. You can set the output of the switcher slightly above the 2.5 V, then use an LDO to convert that voltage to the actual 2.5 V. The ammount of headroom required will depend on…
Hi, Kay
TPS65270 can compete MP2223.
Besides,
For larger loading and 2 channels, there are TPS65273V, TPS65276V, TPS65279.
And there are 3 channels devices, TPS65261, TPS65263, TPS65265.
