Part Number: TPS65400 Other Parts Discussed in Thread: TMS320F28P550SJ Tool/software: Hi Ti team
The following are questions that have not been answered before. Can you reply again?
We hope that during system startup or charging, no power is supplied…
Part Number: TPS65400 Tool/software: Hi Team,
Customer hope that during system startup or charging, no power is supplied to chips other than the MCU. When needed, the MCU should control the PMIC to supply power.
Currently, on the customer's schematic…
Part Number: TPS65400-Q1 Tool/software: Hello,
Could you confirm to me if the values suggested in Webench® Designer's "Bill of Materials" are still confible?
I ask why when performing the simulation in:
https://www.ti.com/product/TPS65400-Q1
…
Part Number: TPS65400-Q1 Tool/software: Hello,
I'd like to say that I am not very familiar with PMU. My concern is the harmonic components.
My question is how to deal with these harmonics in general. We have AC-coupled shown in Figure 8-10 of datasheet…
Part Number: TPS65400 Other Parts Discussed in Thread: USB2ANY Tool/software: Can the software provided with the TPS65400 EVM be used to program the registers on my target design? If so, is there a subset of the thirty pin connector I can include in my…
Part Number: TPS65400 Tool/software:
We have developed a power module using the TPS65400 PMIC to power the XC7Z020 Zynq SoC . The module includes a provision for a 5x2 header compatible with USB-to-Any interface for configuration and…
Part Number: TPS65400 Tool/software: Hi team,
It is described that default t_ON_Delay/ t_OFF_Delay are 5ms. However, Fig.8-4 looks there is no delay time.
Is this the example of the case that delay time is zero?
Best regards, Goto
Part Number: TPS65400 Tool/software: Does the TPS65400 need to have a host or I2C controller in order to function?
Can the pins be hardwired to do something simple like setting the output voltages?
Part Number: TPS65400 Dear TI team,
Base on the PMIC TPS65400 datasheet, there have 4 Switching regulator(SW1,SW2,SW3,SW4), and the PMBUS command can sets the VREF(values from 0.6V to 1.87V).
Question:There have 4 VREFs, VREF1 for SW1. VREF2 for SW2…
Part Number: TPS65400 Tool/software: Hi, for my new design i have used tps65400gzr and for the communication i have got sda, scl and gnd to J tag connector, will this work and what software can I use for programming the ic through i2c,
