Search tips
Showing 15 results View by: Thread Post Sort by
    Answered

  • TPS65735: Can I use two of them in parallel?

    Resolved
    Part Number: TPS65735 Tool/software: Hello all, I have a design which has to drive four LC shutters, powered by a single battery. TPS65735 fits well for that, except that I need four H-bridges. So I want to use one TPS65735 for power/battery management…
    • Resolved

  • TPS65735: There is a problem with TPS65735 detection

    TI Thinks Resolved
    Part Number: TPS65735 The BTL output end of LCRP--LCRN of PCB TPS65735 is connected to oscilloscope for test. The waveform tested under no-load condition (or connected to 1M resistance load) is as follows. The timing signal of this waveform is normal…
    • Answered

  • TPS65735: Voltage level on H-Bridge Input pins

    Resolved
    Part Number: TPS65735 Hi, Can anyone let us know the Max voltage level on the H-Bridge Input pins (HBL1, HBL2, HBR1, HBR2 ) of the TPS65735 IC? We have found the min level for the GPIO high level (BST_EN, CHG_EN, SW_SEL, VLDO_SET and to switch H-Bridge…
    • Resolved
    • Answered

  • TPS65735: End of life & Application

    Resolved
    Part Number: TPS65735 Other Parts Discussed in Thread: TPS65835 Hi, Can anyone let us know the end of life of the TPS65735 IC and can we use this IC for synchronization the 3D Glass? Thanks, Yamini
    • Resolved

  • TPS65735 for LCD shutter

    TI Thinks Resolved
    Other Parts Discussed in Thread: TPS65735 Hello, I would like to drive LCD panel with the TPS65735 but for choosing my LCD panel i need to know the max capacitance this chip can handle ? Can you help me about that ? Regards,
    • Answered

  • TPS65735: Max Lswitching speed possible, ability to drive 4 shutters instead of 2 and any leads on shutter suppliers and shutter type info?

    Resolved
    Part Number: TPS65735 Hello, I have several questions regarding the TPS65735 PMIC. We have an unusual design where we need to control 4 LCD shutter at once, not two. I would like to know: 1) What switching speeds are possible? I would ideally…
    • Resolved

  • TPS65735 application question?

    Other Parts Discussed in Thread: TPS65735 Dear Sir My customer want use use TPS65735 to replace ST9902, but here to measure output waveform. TPS65735 and ST9902 output waveform are the same. But TPS65735 connect to 3d glass, the 3D glass have no response…
    • Answered

  • TPS65735 charge pin question.

    Resolved
    Other Parts Discussed in Thread: TPS65735 Dear Sir Good days, As i check TPS65735 EVB circuit, CHG_STAT connect to SYS, CHG_EN connect to VLDO. is there mean we need press S1 switch first, then we have chargering function? If we want have chargering…
    • Resolved
    • Answered

  • TPS65735 Vcomp function question?

    Resolved
    Other Parts Discussed in Thread: TPS65735 Dear Sir As I understand from Datasheet, Vcomp = Vbat *Rbscl1/(Rbscl1+Rbscl2) and used Vcomp voltage to MCU foe monitor Vbat voltage. But from datasheet page 23, here show VCOMP = 0.5 ×VVLDO + 300 mV, I am…
    • Resolved
    • Answered

  • TPS65735 EVB 10 kΩ NTC thermistor question?

    Resolved
    Other Parts Discussed in Thread: TPS65735 Dear Sir We can't find NCP18W103J03RC datasheet(TPS65735 EVB suggest part). May you suggest NTC part for us? Best Regards, Bogey
    • Resolved

Didn't find what you are looking for? Post a new question.