The TI E2E™ design support forums will undergo maintenance from July 11 to July 13. If you need design support during this time, open a new support request with our customer support center.
Part Number: TPS65912
shown as the picture above , when my MCU power on, I do the GPIO init firstly, then I set the registers to enable ENx pins 、AVS voltage、OP voltage etc.
the TPS65912 will output default voltage immediately , this will destroy other…
Part Number: TPS65912 Hi team,
Due to EOL of Intel power device: ES1030QI , I found TPS65912 as alternative . C ould you please help suggest whether this part is suitable? Please correct me if you have better suggestions. Thanks a lot!
Thanks & best regards…
Part Number: TPS65912 Other Parts Discussed in Thread: TPS650830 Hi
Customers now want to use TPS650830 on ADL-M, if you have some questions, please ask:
1. VR2, VR3, VR5 remain unchanged, VR1 is adjusted to 1.05V/4.3A, VR4 is adjusted to 1.05V/6A for…
Part Number: TPS65192 Other Parts Discussed in Thread: TPS65912 From datasheet, it stated that TPS65912 supports both SPI and I2C interface.
When configured to use SPI interface, can SPI access all the TPS65912 register ?
Section 7.18 stated that the host…
Part Number: TPS659128 Other Parts Discussed in Thread: TPS65912 Tool/software: Hi team,
The data sheet states that four I2C addresses can be selected via OTP.
Is it possible to purchase two types with different addresses?
If possible, is it possible…
Part Number: TPS65912 Hello,
unfortunately i can not change the limit register values per I2C, but the data sheet says that the two registers are writable.
LDO1 is limited to 0.925V and LDO4 to 2V, is it possible to change these registers to different…
Part Number: TPS65912 How should unused LDO inputs (VINLDO) be connected?
The OPT8241-CDK-EVM SB schematics (that eval board uses the TPS659122 PMIC) connect unused VINLDO pins to GND. Is it ok to leave unused VINLDO pins unconnected, or must they be…