Part Number: TPS659128 Tool/software: Hi,
We wants find below replace part, I found TPS659128 should be suitable but we need can write default setting into PMIC OTP.
May I know there have any minimum run rate requirement or fee for OTP? Thanks!
Part Number: TPS659128 Tool/software: Hi Team,
Could you please help to check the negative voltage spec in SW for each Buck?(DC-DC1 to DC-DC4)
Thank you
Yishan Chen
Hi Yishan,
I can confirm the official data says the Absolute Maximum is 3.6 V. "This is because the maximum output of the PMOS LDO is 3.3V, with the addition of 300 mV headroom."
This cannot be changed.
Again, apologies for the delay in this information…
Part Number: TPS659128 Hi team,
The datasheet shows the absolute rating on DC for each pin. The customer wants to know that how much transient voltage the SW pin of TPS659128 can stand such as -2.5V within 2us.
YOURS
NAN
Part Number: TPS659128 Hi,
I have 2 quesitons for TPS659128.
1. Does it have EVM and EVM reference design can reference?
2. Does TI can support default FW setting before shpping? I've check "8.3.1.4 LDO Enable", it said "Each LDO regulator can be factory…
Part Number: TPS659128 Hi Team,
A customer is asking for the default OTP settings of TPS659128x PMIC? This was not included in the datasheet.
The customer is looking for a PMIC with specific OTP settings to avoid the need of I2C-based configuration during…
Part Number: TPS659128 Other Parts Discussed in Thread: TPS65219 So I chose this PMIC as the AM6234ATCGGAALW recommends using this PMIC in conjunction with itself.
However, the reference designs for this Sitara and similar parts use a more distributed single…
