Hello Matthew,
Matthew Strickland said: It appears the GUI requires more than just an I2C connection, please confirm.
This is true, it requires a hardware intermediate, namely a MSP432 device with the correct firmware to perform the writes.
Matthew Strickland…
Part Number: TPS6593EVM I received the TPS6593x EVM from Gerold/Brenda. I have the GUI installed, but cannot connect to the EVM. I get a message "Connected to AEVM controller, but can't connect to TPS6593x..."
Why does the paper tag on the…
Part Number: TPS6593EVM Hello
We have an eval board which we cannot communicate with.
The problem is that we don't have a valid COM port until the usbser device driver is not properly installed on windows.
I find the driver files on local computer…
Part Number: TPS6593EVM Hi,
if the signal "ENABLE_MASK" in the interrupt mask register is set to "Interrupt not generated.", the power up sequence does not start and all Buck and LDO outputs remain switched off. If the signal "ENABLE_MASK…
Part Number: TPS6593EVM Hi,
after connecting with the evaluation board and start of "SCAN FOR DEVICES" the message "NO DEVICES DETECTED" and "Duplicate devices names (or) invalid name found" are reported.
The evaluation board…
Hello,
The NVM of this device is configured so that NRSTOUT pin is not actively driven. This is described in the User’s Guide Programmable PMICs: TPS6593-Q1 Default Configuration for TPS6593EVM . You can go to the register map page in the GUI,…
Hi Kiran,
TPS65916EVM is intended to be used as a tool for evaluating the TPS65916 device for mass production. It's not intended to be used as a test tool. Within that scope, I can try to help.
I should clarify - you can configure it to SPI using the…
Part Number: TPS6594-Q1
This FAQ will cover the situation of how-to setup the Watchdog in trigger mode via I2C writes.
Since this FAQ covers multiple parts, there will be slight differences on the implementations will be noted by [TPS6594 / TPS6593]…