Part Number: TPS709-Q1 Good day colleagues,
My customer is using two voltage regulator TPS70950QDBVRQ1 to power external sensors. See circuit diagram section.
On the customer side, they have to ensure short-circuit protection according to UBatt and GND…
Part Number: TPS709 Hello team,
TPS709 datasheet has Vdo vs VIN curve for TPS70965 (6.5Vout version) at Figure 6-9. Do you have this curve for TPS70933? Can I estimate TPS70933 will be same curve as Fig6-9 under the range of VIN=2.7V-3.3V?
Customer want to…
Part Number: TPS709 Goal is to create 3.3V from 15V
If operated without load it only regulates up to a Vin of 9.7V the output correctly.
Beyond that the Vout increases according to Vin.
If the output load is 660 Ohm everything is fine.
Are there some…
Part Number: TPS709 Hi Experts,
Our customer is asking if there is an overview available where he can see the max power dissipation of all TI packages?
Or an application note or Excel file to calculate the power dissipation?
Thank you and best regards…
Part Number: TPS709 I am using a TPS70930 to trip a switch when a charging capacitor reaches a certain voltage. From the datasheet I figured that the EN voltage was at 0.9V at a minimum but in practice I found it to be around 0.5V, is this correct?
…
Part Number: TPS709 Hello,
I ran a simulation with LTspice using a PSpice model of TPS70950 provided by TI.
I want to use this regulator with floating ground, so I used square-wave voltage source as the ground.
The schematic is as follows.
As a result…
Part Number: TPS709 Dear Sirs,
I want to suggest TPS709B33 for HT7533 SOT23-6 replacement as p2p solution.
However, customer said they used the below design of HT7533.
May I know if TPS709B33 can do the same design or not?
Thanks.
www.holtek.com/...…
Part Number: TPS709 Hi Expert,
Could you please let me know about the following figure at Vin=24V?
Can we estimate it will be linear increasing to 24V?
Do you have the figure that is showing to 24V?
Current limit spec
Test condition is note (4). …
Part Number: TPS709 Hi team,
Could you let me know the maximum IN pin current in shutdown for TPS70950?
From Figure 6-17, the maximum ground pin current in shutdown looks like ~250nA.
In this thread , it is mentioned that EN pin current can be up to 600nA…