Part Number: TPS709 Hi team,
Could TPS709 be the p2p replacement for LT1761ES5-BYP#FBP 1.2v-20v SOT-23?
Do you have other p2p replacement suggestion for that?
Thanks a lot
Matthew
Part Number: TPS709-Q1 HI ti
On board etc equipment is using tps70936qdbvrq1 for 5V to 3.6V,;
It is found that one prototypes have abnormal current, and the normal working current is 20~50UA, but the fault prototype reaches 87mA. Finally, it is found…
Part Number: TPS709-Q1 Other Parts Discussed in Thread: TPS709
Hi team
There is a good new that we could DIN TI product!
Customer is looking for the replacement of SGM2203 (P2P would be better )
Please help confirm whether SGM2203 can be replaced with…
Part Number: TPS709 Hi, as both TPS70928DBVR and TPS70928DBVT are currently out of stock and will cause a delay to our production very soon, is there a drop-in replacement for TPS70928DBVR? Thank you!
Kai
Part Number: TPS709-Q1 Other Parts Discussed in Thread: TLV733P-Q1 Hi,
The customer is considering TLV76733DRVR instead of TPS70933QDRVRQ1. PIN 2 and PIN 5 are different, as TPS70933 has NC for both PIN 2 and 5 but TLV76733 has SNS and GND for PIN 2 and…
Part Number: TPS709 Dear TI expert,
As shown in TPS70933DBV datasheet, there is an internal 6.5V Zener diode, do you have the allowed current of 6.5V Zener diode ?
Hope to get your feedback ASAP.
Thanks in advance.
Xiangdong.
Part Number: TPS709 Hi expetrs,
Good day to you!
1. When the input is grounded through a pull-down resistor and the output voltage is equal to 3.6V(conneted with a battery), does current flow from the output to the input?
2. Does the PMOS in the picture…
Part Number: TPS709 Hello,
Wanted to double confirm this is ok:
We would like to connect EN and NC together. The datasheet says there is no internal connection on NC, so should not be a problem.
Do you have any concerns?
Thank you, Keith
Part Number: TPS709 Other Parts Discussed in Thread: TPS7A25 Hey Team,
I have a question regarding the TPS709 and TPS7A25 series LDOs.
Would it cause any adverse effect to connect pin 1 (vout) to pin 2 (NC) on these parts? All versions we are using are…