Part Number: TPS754 Tool/software: In my regulator, the input voltage is 3.3V and required output voltage is 1.8V. Please go through my schematics and provide feedbacks for it
Thanks and regards
Abhishek
Part Number: TPS754 Other Parts Discussed in Thread: TPS7A54 Tool/software: I am looking for a low-noise LDO that can output 5V at a 4A load and handle an operating temperature of -55°C. I came across the TPS715401. However, I am confused about the difference…
Part Number: TPS754 Hi,
I'm designing a board with the TPS75401-Q1 linear regulator.
Regarding the selection of the ouput capacitor it seems tat the ESR is critical because it has to be greater than 0.1 Ohm or 0,05 Ohm depending on total capacitance…
Part Number: TPS754 Other Parts Discussed in Thread: TPS752 Hi Team,
My customer wants to know following info, could you kindly help? Thanks.
1. I think "EN" pin controls output voltage, how long is the time needs to turn off Vo after EN became high…
Hi,
We do not have any plans to discontinue this device so we do not have any End of Production, EOL, or End of Sales dates. As for your other questions see below
1. Start of Production(Release date/Start of selling Point) : 2000/03
2. Discontinued…
Hi Naji,
As you state, the TPS754 output is enabled when EN is pulled to logic low. The output is disabled when EN is pulled to a logic high. The push-pull RESET of either TPS3824 or TPS3825 will be pulled to a logic high (the value the supervisor…
