Part Number: TPS795 Hi,
Regarding TPS79501 (VSON8) I have a question about the connection of the thermal pad. Should the thermal pad be connected to GND or should it be left floating? Unfortunately I did not find any information on the datasheet.
Thank…
Part Number: TPS795 Hello,
I am using this circuit. i have tested it on board as well as alone. Each time the IC shows the correct value for the first time then it burns. I have tried it several times. please help.
Part Number: TPS795 Hi Team,
I didn't see the maximum output capacitor limitation in TPS795's datasheet. I'm not sure whether TPS795 can work well with big capacitor as long as it's bigger than 1uF. If not, what's the maximum limitation for output capacitor…
Part Number: TPS795 Other Parts Discussed in Thread: TPS793 hi TI expert
now，used tps79501 convert 1.2V，at the power up,found the curve was not monotonou,has much step , could you give some support ,
the same issue was found at tps79318,refer the…
Part Number: TPS795 Hello,
In my established design a TPS79533 regulator is powered by a 5V supply that also powers a microcontroller. The same microcontroller enables the TPS79533 at arbitary times during operation. Sometimes the dip on the 5V supply upsets…
Part Number: TPS795 Other Parts Discussed in Thread: LP5912 , Hello!
Now I'm designing some receiver for ISM standard. I have 5 V from switched regulator and need good LDO for 3.3 V. When I choose the LDO I saw for TPS79533 and LP5912-3.3 and I don't see…
Hi Patrick,
You are correct, most of our devices in this space will be in a 2mm x 2mm package.
The following devices will be in the 3mm x 3mm but not exact P2P as most of our devices in this space have 8-pins:
TPS735 and TPS795.
We have many more options…
Hi Jim,
Thank you for all of the information! Would it be possible to post a scope shot with Vin, Vout, EN, and Iout? This will help give a better indication of what is going on.
Increasing the input capacitor will help the upstream device supply…
