Part Number: TPS7A11 Hello all,
I am using the TPS7A1118 to provide1.8V with the following set up, to supply an ADC:
-Vin = 3.3V
-Vbias = 3.3V
-EN = 3.3V (all 3 pins are tied to 3.3V power plane)
-The NC pin is not connected, and GND pin tied to thermal…
Part Number: TPS7A11 Hello, I am going to use TPS7A11 LDO for my system.
LDO's PSRR is important factor. And in the datasheet, there is only TYP spec of PSRR.
Doesn't PSRR has Min or Max Spec? There is no defined Min or Max Spec of PSRR.
I think…
Part Number: TPS7A11 Dear team,
Customer want to use TPS7A11 for 1.1Vin to 0.75Vout/0.11A, and Vpp need to within 1% spec(constant load).
Did we have simulation or calculation can verified device performance?
Regards,
Ben
Part Number: TPS7A11
All,
One of my customers is using the TPS7A11 to power an FPGA rail. Maximum output capacitance for the TPS7A11 is 22 uF; minimum capacitance at the input of the FPGA is 47uF + 4 100 nF, trace is about 1 cm. What is recommended…
Other Parts Discussed in Thread: TPS7A11 Hi all,
TPS7A11 series LDO is used in our design to supply wide range of voltages @ different current loadings.
Kindly review the schematics and layout attached, and provide your valuable comments ASAP.
Note:
…
Part Number: TPS7A11 Hello team,
I have a couple of question about TPS7A11 output voltage option. 1) It looks TPS7A1108(0.8V option) has only PDRV(WSON) and not PYKA(BGA) on the datasheet. Isn't it just a miss-information or can we order TPS7A1108PYKA…
Part Number: TPS7A11 Hello team,
I have a couple of questions regarding TPA7A11 start up time. It is defined 525us(typ), 1200us(max) from EN toggle with Cout=2.2uF on the datasheet. 1) Is the start up time determined by internal timer? 2) Does it have dependency…
Part Number: TPS7A11 All,
Customer question on the output capacitor (capacitance) for the TPS7A11, I see in the datasheet a maximum output capacitor of 22uF placed as close as possible to the output pin. In this case Cout is 4.7uF, so OK here.
At the…
Part Number: TPS7A11 May need just a bit more current than 500mA @3.3V output.
Application is a remote device in automotive/industrial environment that uses a 900MHz Radio that requires 380mA current. Using one TSP7A11 may be marginal.
Can you connect…