Part Number: TPS7A24
Tool/software:
Hello LDO team,
Is the TPS7A2430DBVR produced on 300mm wafers and is there any foreseen EOL risk?
Thank you.
Kind regards,
Wouter Kragt
Part Number: TPS7A24 Dear Concerned, I am looking for below specifications for MPN: TPS7A2425DBVR. Please help to share ASAP.
1. Power Dissipation 2. Enable Input Voltage
Thanks Pravallika.
Part Number: TPS7A24 Other Parts Discussed in Thread: SN6505B , Tool/software: Team,
I'm doing a design with a TPS7A24 as a crude pre-regulator for a SN6505B. I have a few questions about my configuration, which is described below and drawn in the image…
Part Number: TPS7A24 The recommended output capacitance rating in the TPS7A24 datasheet is very confusing.
The customer would like to use TPS7A2450 with 47 uF of tantalum capacitance plus some additional 20 uF of ceramic capacitance on the output. …
Part Number: TPS7A24 Tool/software: Hi sir,
could you please help us review this layout? for U14, which is the TPS7A2433 low-dropout voltage regulator.
does our layout planning have any issue? thanks for your great support and learn from you.
…
Part Number: TPS7A24 Tool/software: Hi expert,
Could you help to recommend suitable device to replace SGM2211-ADJXN5G/TR? P2P would be better. Thanks.
SGMICRO-SGM2211.pdf
Best Regards,
Ryker
Part Number: TPS7A24 Tool/software: Hello,
I am using the TPS7A2401 in the attached circuit. This is the 5.5V section only. The load is light at around 10 mA. The output of the TPS7A24 is stable below 6.5V input,
but it rises along with the input…
Part Number: TPS7A24 Tool/software: Hi team,
Could you please check if the EN pin of TPS7A24 accepts High signal while VCC=0V?
This is critical for my customer's use case.
Best regards,
Kazuki Itoh
Part Number: TPS7A24 Tool/software:
From the datasheet, I understand that Input Capacitor has to be 1uF typ as a good design practice. Please can you comment on the minimum input capacitance needed.
In my design with input to LDO as 6V, I am using…
