Part Number: TPS7A39
Dear team,
A waveform at boot up has been received from our customer. The waveform becomes in an overcurrent state at boot up during around 50ms. Does this not have any problem? Does it not cause the damage to device?
TPS7A3901 tuen…
Part Number: TPS7A39 Hi team,
Could you tell how to deal with INN & OUTN & FBN when they don't use the negative output?
They just want to use the positive and want to understand how to deal with pins that are related to the negative.
Regards…
Part Number: TPS7A39 Other Parts Discussed in Thread: OPA2210 , Dear SME, my circuit input is +-12V, the output is +-5v used for powering amplifier OPA2210. +-12V go through 1amp fuse and supplied to TPS7A3901.
however, when I powered on +-12V, the 12V…
Part Number: TPS7A39 On page 22 of the data sheet SBVS263A are the following in Table 2.
VINP < VUVLOP – VHYSP and VINN > VUVLON – VHYSN
I do not find a definition or spec for VHYSP and VHYSP anywhere. In the datasheet
or by using a search…
Part Number: TPS7A39 Hello guys,
One of my customers is evaluating TPS7A3901 for their next products.
They checked the output of TPS7A3901 with FFT.
Then they found the output peak frequency was around 940kHz.
Do you think their FFT result is correct? …
Part Number: TPS7A39 Hello,
For TPS7A39 positive and negative dual LDOs，can I use only positive output channel？
If it can be used, what should be noticed in the circuit design?
Part Number: TPS7A39 Other Parts Discussed in Thread: TINA-TI , Hi,
I was trying to use the component models in TINA for the TPS7A3901 from your website https://www.ti.com/product/TPS7A39
When inserting into tina I get a macro error
Both of the models I…
