Part Number: TPS7A4501-SP Do we have a table or graph showing typical input line regulation?
I see the specification at Vin from 2.9V to 20V, OUT changes 2.5mV typ and 6.5mV max.
A graph would show if the voltage is increasing or decreasing with input…
Part Number: TPS7A4501-SP We are currently modeling the TPS7A4501-SP WCA and looking at the loop gain. What is the maximum output capacitance that this part can drive during turn on and steady state? When using the WCA model and measuring the loop gain…
Part Number: TPS7A4501-SP Page 7 of the latest datasheet (Aug 2015) specifies the load regulation of 18mV over the full temperature range and from 1mA to 1.5A (with 2mV typical at 25C).
On pages 13-14 (section 8.3.1) there is an example calculation where…
Part Number: TPS7A4501-SP What is the Back Side Pad Metalization (Thermal Pad) Material?
I'm soldering this component to a Polyimide PCB with Sn63Pb37. I was hoping to investigate the CTE mismatch between device & board.
Thanks,
Zach
Part Number: TPS7A4501-SP
The thermal resistances I see in the datasheet for the HKU package seem odd to me. Specifically, the junction to bottom-of-case thermal resistance is quite low at 6.6 C/W, but then the junction-to-board thermal resistance is…
Part Number: TPS7A4501-SP Figure 18 of the current datasheet shows output Ripple Rejection vs. Frequency at Vin= 2.7V and Iout = 750mA but I can't find any indication of what the Vout was for the graph.
What was the Vout for the data in Figure 18…
Part Number: TPS7A4501-SP Other Parts Discussed in Thread: LM117 , TL1431 , We previously used an LM117 to regulate a -200 vdc supply by elevating the potentials on the input and output. The idea was taken from a TI application note. We are trying to get…
Part Number: TPS7A4501-SP How fast does the LDO output voltage change in response to application of the SHDN pin signal?
How fast will the LDO come up when the SHDN pin transitions from LOW to HIGH?
What is the minimum duration of the of the SHDN pin signal…
Part Number: TPS7A4501-SP The table in data sheet section 7.6 lists Current Limit as 1.9A typical for a differential voltage of 7V. Data sheet Figure 14 shows the Current Limit as about 2.4A typical for the same differential voltage. Which one is correct…