Part Number: TPS7A4701EVM-094 Tool/software: Hi Team,
We recently purchased a couple of eval boards( TPS7A4701EVM-094 ) for TPS7A4701 device from Mouser. As per the datasheet the device should be able to source up to 1A of current but unfortunately…
Hi,
Chenglai FANG said: If I use a network analyzer, how should I avoid the noise from the probe?
Vin and Vout should be measured with high-impedance probes (either scope or network analyzer) immediately at the Vin or Vout pins to minimize the set…
Part Number: TPS7A4701EVM-094 Tool/software: Hi,
I require assistance in setting up a test set-up for the EVM. I am using Rigol Electronic load to check for the current output. When I connect Vout and Gnd of the EVM to the Rigol load and set it in…
Part Number: TPS7A4701EVM-094 Hey team, I had one of my customers have concerns over a couple EVMs blowing up - see below
"I have purchased two of TPS7A47xxEVM-094 now and both have blown up as soon as 30V was applied. I checked the voltage and it was…
Part Number: TPS7A4701EVM-094 Hello,
When using the TPS7A4701EVM at output current of 1A and voltage drop of 4V, is this enough PCB area to dissipate the 4W of heat through the bottom package solder pad and the PCB, or I have to add the heatsink attached…
Part Number: TPS7A4701EVM-094 Other Parts Discussed in Thread: TPS7A4701-EP , Hi,
Our application is to use this LDO part TPS7A4701-EP in adjustable opration with switching some values on the R2.
Could you help check if R2 Values and Calculated…
Part Number: TPS7A4701EVM-094 Hello,
I am using the eval board, with the test setup described in the user guide. However, when the enable jumper is turned to ON it looks like there is a short, the input voltage drops from 12V to 2.5V. Current draw is…
Part Number: TPS7A4701EVM-094 In the user guide for TPS7A4701EVM-094, it mentions "before connecting the input power supplyto the EVM,verify that the output voltage is set to the desired supply voltage(+3 V to +35 V range)and that it is current limited…
Part Number: TPS7A4701EVM-094 Other Parts Discussed in Thread: TPS7A47 , TPS7A4701-EP , 1. What will be the recommended R1, R2 value for a 34v output adjustment?
2. Any recommended type of resistor type/brand?
Regards.
