Part Number: TPS7A49 Hi,
i'm in midst of running some high temp test on TPS7A4901DGN with regulator step down from 12V to 9.3V.
Recently we found thermal issue on this device, my initial suspect that this issue was caused by output current consumption…
Part Number: TPS7A49 Hi Expert,
Customer is using TPS7A4901 on their design. the input voltage is 24V and output voltage is 15V, output current is lower than 100mA in normal operation condition. Besides the 10uF output capacitor, another 100uF is added…
Part Number: TPS7A49 Hello,
Based on the data sheet on TPS7A49, I can see 2 types of the power PAD size. Page #33 is 1.89(max)x1.57(max), page #36 is 2.15(max)x1.846(max). Which size should we design the land pattern of PCB? Please advice.
regards…
Hi Mark,
The NR pin allows for an external capacitor to be used to filter the internal reference of the TPS7A49. Since the output voltage is a gained version of the reference, the NR pin should ideally be completely isolated from any other voltage rail…
Part Number: TPS7A49 Hi there,
we use TPS7A4901 in 19V--->12V application, normal I_load is 100mA or so. We have some questions to consult on its current limit behavior in case of over load current occurs.
Quote: "section 8.3.1 and 8.3.4 of datasheet…
Thank you for the concrete recommendations.
As the TI article for the tracking supplies as the feedback as a "servo" voltage feedback - I guess that the bandwidth of most positive regulators would be sufficient (with regard to loop stability), so I…
Part Number: TPS7A49 I have managed to get a solder bridge shorting Pins 2 and 3 (SSOP pkg). I have tried to correct the short without joy. The DS says that Pin 3 is not internally connected. That would lead me to believe I don't have a problem. Am I…
Part Number: TPS7A49 Hi there,
We are using TPS7A49 LDO to convert 15 V DC to 5 V DC (Current Requirement: 20 mA). Our 15V DC source can supply maximum current of 200 mA. Please let us know that if the 5V output of LDO is short-circuited, then would…
Part Number: TPS7A49 Hi,
We are using the TPS7A49 to regulate 20V to 18V for a low noise supply. However, when testing the circuit on the PCB, the output voltage is too high (measured 19.3V). After reading other threads, we determined the cause to be…
