Part Number: TPS7A52-Q1 The INR/SS value in the datasheet's 6.5 Electrical Characteristics table is listed as Typ 6.5uA.
However, 8.1.1.2 Noise-Reduction and Soft-Start Capacitor (CNR/SS) states 6.2uA.
which is correct : 6.5uA or 6.2uA
Datasheet…
Part Number: TPS7A52-Q1 Hi there,
For the TPS7A52-Q1, if we want to make the supply add noise on the output, can we AC couple in a sinusoidal voltage at the NR pin, or add it to the FB pin. The idea would be to test with the linear regulator for low…
Part Number: TPS7A52-Q1 Other Parts Discussed in Thread: TPS7A52 , TPS74801-Q1 , TL1963A-Q1 , TPS748A-Q1 Tool/software:
Hello Team,
Currently we are using 2* TPS7A52-Q1 LDOs in our design.
We were trying to measure the No load Current on TPS7A52…
Part Number: TPS7A52-Q1 Other Parts Discussed in Thread: TINA-TI Tool/software: I tried to do the simulation with TPS7A52-Q1 in LT spice with the unencrypted and Encrypted Model. Both show error. Kindly share the model without error. The simulation was…
Part Number: TPS7A52-Q1
Hi Team,
Kindly Review the attached Schematic Circuit of TPS7A52-Q1 and provide the feedback.
Below mentioning the design details.
Input Voltage - 4.6V (VBAT_LDO)
Output Voltage - 3.3V (VDD_3V3)
Max Load current - 1…
Part Number: TPS7A52-Q1 Hi Support Team,
For our of our product we are planning to use TPS7A5201QRGRRQ1. We are concern on the accuracy part. From the datasheet we have taken the below snapshot
Please help me to understand how this accuracy is derived…
Part Number: TPS7A52-Q1 Hi Expert,
Would you mind sharing the detailed package (with detailed footprint) of TPS7A52-Q1 with me？
The datasheet doesn't contain the detailed description.
Thanks a lot for your warm help!
Part Number: TPS7A52-Q1 Hello,
The datasheet mentions utilizing a 12.1kohm resistor, as R1 of the voltage divider, to optimize noise and PSRR. To get an 0.85V output and maintain a 5uA resistor divider network, a 10kohm R1 resistor and 160kohm R2…
Part Number: TPS7A52-Q1 Hi,
I am using TPS7A5201-Q1 LDOs in my design.
One LDO is used to generate 0.9V (@0.4A) from 1.2V
Another LDO is used to generate 1.2V (@1A) from 1.5V.
I am connecting 5V supply to the BIAS pin of both the regulators…
