Part Number: TPS7A8001DRBEVM We have to test our LDO in temperature around 150C. Does thsi EVM meets this spec. Or Suggest me any alternate EVM part number compatible for this 150C operating temperature with same pin mapping and spec as TPS7A8001DRBR
Part Number: TPS7A8001DRBEVM Dear Team,
1. For TPS7A8001 For P3V3_CLK (1A, 0.364A), power-on/off is normal at no-load, and there is a large loopback when power-on/off at full load with 0.36A, which may cause the power supply to turn on by mistake…
Part Number: TPS7A8001DRBEVM Dear team,
Customer design TPS7A8001 on their board and find a problem when start up in the following use case.
They can see two different slew rate and a vibration during start up.
Could you share your comments…
Part Number: TPS7A8001DRBEVM Other Parts Discussed in Thread: TPS7A80 Hi there,
I'm looking for a replacement of NCP59800 from Onsemi.
1. Could you cross-check if this DFN8 package is directly replaceable with TPS7A8001 VSON package? When I compared…
Part Number: TPS7A8001DRBEVM Hi,
Please see the oscilloscope shot. Can I ask you why the two scope shots are showing such a big different operation? The input current in second shot with the lower Cout keeps touching zero and increasing periodically…
Part Number: TPS7A8001DRBEVM Other Parts Discussed in Thread: TPS7A80 Hi team,
I'm evaluating TPS7A8001 EVM as the customer has an issue on the their board. I have several question about the basic operation of this device.
Please refer to the slide…
Part Number: TPS7A8001DRBEVM Hi,
My customer measured the bode plot of TPS7A8001EVM when Vin=3.3V and Vout=1.8V. They found the bandwidth is only 100Hz. But LDO is supposed to have larger bandwidth. Could you help check it?
Thanks.
Other Parts Discussed in Thread: TPS7A8001DRBEVM Hello,
Does anyone help to explain why Vout goes down with a step(marked in red) when Vin and EN is down? And why after the step Vout is going to 0V very fast?
Thanks
Vincent
