Part Number: TPS7A84 Tool/software: Dear team,
Except the output voltage range, is there any characteristics differences between ANY-OUTPUT and resister programming.
Like the transient response, power dissipation....etc
Best regards,
Hank Lin
Part Number: TPS7A84 Other Parts Discussed in Thread: TPS7A57 , , TPS7A85A Dear BU friends,
Could we support TPS7A84 parallel to achieve 5A application. Customer prefer TPS7A84 due to the setting voltage is convenient for customer.
Part Number: TPS7A84 Hello Experts,
Refer Table 8.5 for feedback resistor values for setting the output voltage.
Can R1 be 6800 ohm and R2 vary from 30k ohm to 130 kohm (using a I2C potentiometer)? The resultant output voltage can change between 0.84V…
Part Number: TPS7A84 Hi team,
I found that in datasheet, EN should be lower than VIN? What's the consideration here? Can custoemr pull up VIN to 1.8V and pull up EN to 3.3V？
Nison
Part Number: TPS7A84 Hi Teams,
My customer is using TPS7A84 which has Remote sns for ATE application. But the Iq of TPS7A84 is 2.8mA, which is too large for the system. Do we have low iq LDO parts to meet this requirement?
BRs,
Marsh
Part Number: TPS7A84 I would like to know what, if anything, I need to check to correct the output voltage of this regulator.
Vin is 5.1V
Vout = Vin = 5.1V . ANY-OUT is configured for 3.3V.
The IC is configured identically to Figure 8-2 in the datash…
Part Number: TPS7A84 Hi team,
may I know the operation of TPS7A84 when it’s output current exceeds the limitation? How TPS7A84 operates to protect the device from damage? And the protection is auto-retry or latchup? What the kind of overcurrent protection…
Part Number: TPS7A84 Hi Team,
ZTE uses TPS7A8401A, and they have some question when using this part.
Test condition: Vin=3.3V, Vout=2.5V, Iout=0.5A; RFB_up=30.1k, RFB_bottom=7.44k, cff=0.01uF
After the LDO normally outputs 2.5V, the load will have a reverse…
