Because of the Thanksgiving holiday in the U.S., TI E2E™ design support forum responses may be delayed from November 25 through December 2. Thank you for your patience.
Part Number: TPS7B7701-Q1 Tool/software: Hi,
I have a question about LDOs.
Vin(V): 20 Vout(V): 3.3 Iout(mA): 50
I found that the TPS7B7701-Q1 meets the above conditions and has a current limit of 100mA when filtered by these conditions.
Are there any…
Part Number: TPS7B7701-Q1 Tool/software: Hi Team,
Can you confirm what the ERR pin will do with the TPS7B7701-Q1 if I enter a dropout condition where Vin<Programmed Vout?
To clarify for example if I have Vout set to 12V what will the ERR pin do if…
Part Number: TPS7B7701-Q1 HI Team,
We need VOL vs IOL curve over Temperature and similarly VOH and IOH over temperature, We basically looking for electrical Characteristics of VOH, VOL, IOH,IOL, VIH,VIL to find the response over temperature change.
We…
Part Number: TPS7B7701-Q1 Dear team,
I have a problem with TPS7B7701-Q1。
The Vout is designed to be 5V，but our team found that one chip outputs about 7V。 I measure FB pin is 1.74V，normally it is 1.23V，The chip seems still working。
So can you explan th…
Part Number: TPS7B7701-Q1 Dear Sir:
Regarding the TPS7B7701-Q1 protection issue.
Please check to reply us.
Thanks a lot.
B.R
Vincent
１．When the TPS7B7701-Q1 power off. Vin=0V.
The out1 of Antenna line will occur Short to battery to 45V. (no exceed…
Part Number: TPS7B7701-Q1 Hello expert
This IC is connected to GND with the FB pin and used as a current-limiting switch.
In this case, is the drop voltage Max=500mV as stated in the data sheet? Or will it be a different value?
Regards,
Kentaro
Part Number: TPS7B7701-Q1 Hi team.
A customer has a question about TPS7B7701 and wants to confirm. The input voltage of TPS7B7701 is 12V, the output voltage is 5V, and the current is about 30mA. When the EN pin is pulled high, how long does it take for…
