Part Number: TPS923652 Hi team,
My customer is evaluating the TPS923652 for controlling the charging voltage of a NiMH battery pack. The intended application is described below.
Application
NiMH battery charging voltage control.
The device would…
Part Number: TPS923652 1. As per the buck-boost application diagram in the datasheet, the LED string cathode is connected to VIN and not referenced to ground. Our understanding is that this is a non-inverting buck-boost topology with a floating LED string…
Part Number: TPS923652 Hi Team, Could you please recommend a DC‑to‑DC LED boost solution that converts 12 V to a voltage range of 260 V – 400 V (nominally 350 V)?
Their application is a xenon flash lamp, so they don’t have a specified forward voltage…
Part Number: TPS923653 Other Parts Discussed in Thread: LM5176 Section 8.2 of the datasheet shows an example for a boost circuit. 12Vin 36Vout 1A current K = 0.6 Using the equation in section 8.2.1.2.1 gives 26.7uH . The datasheet says I should be getting…
Part Number: TPS923652 Tool/software: Hello,
I’m currently considering using the TPS923652 for an LED application. I understand that the device supports PWM dimming via the DIM pin. However, I would like to ask:
Is there any way to achieve dimming…
Part Number: TPS923652
Tool/software:
Dear Team,
We have used TPS923652 IC in our design for LCD back light control, Rating for LCD backlight are 270mA max current and Forward voltage 9.6V.
As per design followed all the steps, even went through…
Part Number: TPS923652 Tool/software: Use TPS923652 to build a BOOST architecture LED DRIVER. When the LED terminal is short-circuited, there seems to be no protection function? Only the FAULT PIN will be pulled low? (Vin=24Vdc, Iout=0.7A@39~42V (LED…
Other Parts Discussed in Thread: TPS923652 Tool/software: Use TPS923652 to build a BOOST architecture LED DRIVER. When the LED terminal is short-circuited, there seems to be no protection function? Only the FAULT PIN will be pulled low? (Vin=24Vdc, Iout…
Part Number: TPS923652
Tool/software:
Hi,
My customer has been using the TPS923652 to drive UV LEDs, and is experiencing failures.
Under no load, they are seeing the device get hot and eventually burn out or experiencing an overvoltage event.…
Tool/software: Hello expert
I set the LED current to 700mA and applied 3.3V to the EN pin. I applied a 20kHz, 50% duty PWM signal to the other adjustment pin. I plan to turn it on and off from the EN pin. Since I want to use four different colors, each…
