Part Number: TPS92611-Q1 Hi
I wonder is there any specific differnt point when using TPS92611-Q1 for white LED or RGB LED.
For analyze this content, I try to simulate this part on Pspice.
But I cannot find RGB Led (or red led).
Is there RGB led model…
Part Number: TPS92611-Q1 Hello TI Team,
From the datasheet , i understand that the Fault pin will be internally pulled low with a constant current source in the range 500-1000 uA.
Q1. If it is a constant current source, then why we have a range of values…
Part Number: TPS92611-Q1 Other Parts Discussed in Thread: TPS92629-Q1 Hi Expert,
Our customer would like to use TPS92611-Q1 in a radar application. Since TPS92611-q1 can only output FAULT signal to indicate there is a fault but cannot tell which fault…
Part Number: TPS92611-Q1 Hello Team,
Have a good day.
We have 2 requests as follows:
Our customer facing stock unavailability issue for the below line items. Hence Please provide supplier contacts for the same.
Also, Please support to identify the alternate…
Part Number: TPS92611-Q1 Hi Experts,
From the data sheet, I have a question about "Parallel resistor R(P) is recommended to consume 1/2 of the total current at maximum supply voltage.".
I wonder why the Rp is needed?
The Rp connect the In pin…
Part Number: TPS92611-Q1 Hi Team,
I am trying to convert the SPICE model for the TPS92611-Q1 found in the product folder into a TINA model. When I go through the process, I receive the following error:
Can you please help me with the TINA model for this…
Part Number: TPS92611-Q1 Dear Support,
Please advise date code for the part number TPS92611QDGNRQ1?
Please refer to attached photo for reference.
1st line: TI 22
2nd line: 1N3X
Part Number: TPS92611-Q1 Other Parts Discussed in Thread: TPS92633-Q1 , , TPS92610-Q1 Our circuit is shown in the figure below; Our current problems are:
The voltage of three LED lamps driven by the normal out pin is 2.5V * 3 = 7.5V;
When one LED is short…