Part Number: TPS92692-Q1 Other Parts Discussed in Thread: TPS92692 Tool/software: Hi
Our customer has raised some questions about the TPS92692:
1, In the datasheet table2 gives the calculation formulas for G0, wp, wz, could you please tell me about Vo…
Part Number: TPS92692-Q1
Tool/software:
Hi team,
My customer uses 92692 in the constant current boost design, could you please give some comments for below question? Thanks.
The 5V LDO of Vref will be turned off when PWM is low? As shown in the picture…
Part Number: TPS92692-Q1 Other Parts Discussed in Thread: TPS92692 Tool/software: Hi Team,
My customer is evaluating TPS92692-Q1 in their project, could you please help give some comments for below questions?
When the customer is using the TPS92692 as…
Part Number: TPS92692-Q1 Tool/software: If "VIn" is off, What is state these pins?
・ GATE
=>
・ OV
=>
・CSP
=>
・CSN
=>
・PDRV
=>
exp)
Hi-Z? Low?( Internal pulldown?(Resistor value) )
Part Number: TPS92692-Q1 Tool/software: Hi,
I am working on sepic conerverter design for below spcification.
Vin 8V to 16V
Vout 21V
Iout 0.75A
Fsw: 400KHz
i am checking MOSFET drain waveform from 8V to 16V. Till 13V VDS signal is ok. when i cross 14V…
Part Number: TPS92692-Q1 am using PSPICE in Cadence Allegro 17.4. An error occurs in the simulation.
I using olb file of TPS92692-Q1 Boost and Buck Boost PSpice Transient Model (Rev. A) of TPS92692-Q1 data sheet, product information and support | TI.c…
Part Number: TPS92692-Q1 Other Parts Discussed in Thread: TPS92692 hello
when i use the TPS92692, i found that The start-up time of the chip varies with different PWM input duty cycles.
please refer to the follow picture.
the blue line is the input voltage…
Part Number: TPS92692-Q1 Hi, I would like to use IMON to read the average current on the LED output, the pwm frequency is 240Hz. I didn't find any advice for a low-pass filter in the datasheet, is there any recommendation?
Part Number: TPS92692-Q1 Hi, I am designing a buck-boost led driver and I have a question about the output capacitor. I see in the datasheet in the typical information section that Cout is only connected between LED- and LED+ but in the typical application…
Part Number: TPS92692-Q1 Other Parts Discussed in Thread: TPS92692 hello i have one quesion about the TPS92692
information: buck-boost circuit input voltage 9-16V, LED current: 0.34A*duty(0.4)=0.136A
when the input votage reach 12v, The waveform of GATE…